Measurement and Calculation of Breakdown Voltages in CF4 Gas Mixtures
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2017, Vol 5, Issue 3
Abstract
Tetrafluoromethane (CF4) has found industrial applications in power switching and gas insulated circuit breakers although it is considered to be a powerful greenhouse gas. This disadvantage can be overcome by mixing CF4 with gases like Argon and Nitrogen. In order to investigate the dielectric properties of the gases, the breakdown voltages must be measured. An experimental system is used to measure the breakdown voltages of CF4 gas mixtures for different electrode separation between 1 mm and 5mm. By comparing the measured breakdown voltages of CF4+SF6 and CF4+Argon gas mixtures with the corresponding values in the literature, the measurement method and experimental system are verified. Then, the breakdown voltages of CF4+N2 gas mixture is measured, which is lack in the literature.
Authors and Affiliations
Hıdır DÜZKAYA, Süleyman Sungur TEZCAN
Keywords
Related Articles
- EP ID EP484349
- DOI -
- Views 100
- Downloads 0
A Survey of Hyper-parameter Optimization Methods in Convolutional Neural Networks
Convolutional neural networks (CNN) are special types of multi-layer artificial neural networks in which convolution method is used instead of matrix multiplication in at least one of its layers. Although satisfactory r...
Investigation of Single Bolted Connections of Thin Wall U Steel Profiles with Eccentric Behaviour
There is no Turkish standard for bolted connections of thin walled steel elements. In the calculations made according to Eurocode and AISI standards, there are different approaches and behaviours for the same sample. The...
The Effects of Shot Peening parameters on the subsurface properties of AA7075 T6 aluminum alloy
Shot peening (SP) is an important mechanical surface treatment widely used to improve the fatigue life of mechanical components operating under dynamic loads which have been specifically used in automotive and aerospace...
Investigation of Dry Friction Wear Behavior of Zinc-Aluminum (ZnA) Alloys Produced by Mechanical Alloying
ZA alloy powders having different compositions were prepared by mechanical alloying in a spex mill. The mechanical alloying was applied 5 to 8 h and the ball to powder weight ratio was kept at 10:1 by weight. The mechani...
Tent Map based Optimization Method
In the real life, some problems cannot be solved using mathematical methods. Meta-heuristic optimization methods are usually used to solve these problems. One of the solutions used to increase the performance of meta-heu...