Mechanical behaviour of sand stabilised with colloidal silica
Journal Title: Geotechnical Research - Year 2017, Vol 4, Issue 1
Abstract
The response of sand stabilised with colloidal silica aqueous gel is examined in the laboratory, under direct shear, triaxial and normal compression loading, in comparison to that of untreated sand of similar density to evaluate the effect of stabilisation on subsequent sand response. The behaviour of the treated sand differs in important respects from the behaviour of the untreated sand: a significant increase in the angle of shearing resistance is observed at lower stress levels, diminishing with increasing stress level; the peak strength envelope is curved at low stresses for the treated sand only, while at ultimate strength, the envelopes coincide for treated and untreated sands. However, at all stress levels, extreme dilation is associated with the treated sand at peak and ultimate strength conditions. Under normal compression, the treated sand is easily densified, exhibiting higher compressibility than that of sand of similar density. It appears that depending on loading conditions, the aqueous gel alters its structure and has the capacity to absorb or discharge free water; it is of paramount importance to measure volume change and/or pore water pressure change during stabilised sand testing.
Authors and Affiliations
Vasiliki Georgiannou
Keywords
Related Articles
- EP ID EP292338
- DOI 10.1680/jgere.16.00017
- Views 50
- Downloads 0
Impact of highly weathered geology on pipejacking forces
For the Kuching Wastewater Management System Phase 1 project in Kuching, Malaysia, 7·7 km of trunk sewer lines were constructed in the highly fractured, highly weathered Tuang Formation using a pipe-jacking method. The p...
Seismic analysis of pile in liquefiable soil and plastic hinge
Liquefaction is one of the leading seismic actions that cause extensive damage to buildings and infrastructure during earthquakes. In many historic cases, plastic hinge formations in piles were observed at inexplicable l...
Case studies to demonstrate challenges of driven piles on rock
In Wyoming, pile foundations for bridges are often driven on rock materials because of the state’s shallow bedrock stratigraphy. Unfortunately, no static analysis methods are currently available for estimating the resist...
The bearing capacity of footings on sand with a weak layer
Minor details of the ground, such as thin weak layers, shear bands and slickensided surfaces, can substantially affect the behaviour of soil–footing and other geotechnical systems, despite their seeming insignificance. I...
Behaviour of MH silts with varying plasticity indices
It is important for geotechnical engineers to understand the intrinsic and mechanical behaviour of silt as it is presently recognised that there exist gaps in understanding its fundamental behaviour. The behaviour of kao...