METHODS TO REDUCE THE NUMBER OF OPERATIONS OF DIGITAL SIGNAL PROCESSING PROGRAM-CONFIGURED OFDM-SYSTEMS 5 GENERATION FOR REDUCING PEAK FACTOR AND PULSE INDUSTRIAL NOISE EXPOSURE
Journal Title: Телекомунікаційні та інформаційні технології - Year 2018, Vol 123, Issue 2
Abstract
In the article in connection with the adoption of the international standard 5G, which for several years has been developed jointly by the largest telecommunication and IT corporations in the world, the technical requirements for 5G networks compared with the characteristics of existing LTE networks. It is shown that in order to meet the key requirements for 5G networks, new technological solutions for the radio access network, the basic network, the transport network, subscriber devices, as well as the development of various related technologies are needed. It is determined that OFDM technology, for effective use in 5G networks, requires fundamental changes. However, these changes can be achieved by further increasing the computational complexity. The article presents a method for reducing the computational complexity of the digital processing of signals of software-configurable OFDM systems of the 5th generation, which also effectively allows to deal with the disadvantages of power amplifiers (decrease of the peak factor) and the pulse industrial noise exposure. In the calculation of the efficiency of the IOST and OST, the performance characteristics are in the range of 11 to 24%. The influence of the OFDM-system with orthonormal sparse transformation on the signal-to-noise ratio using a channel with frequency-selective fading was conducted. Simulation simulations were performed using VisSim's universal system of block simulation visual mathematical modeling. The effectiveness of the OFDM system with OST compared to the usual OFDM with QPSK modulation, even at low signal-to-noise ratio, is about 17 dB, measured at 10-4 BER.
Authors and Affiliations
A. Makarenko
Keywords
Related Articles
- EP ID EP468535
- DOI -
- Views 75
- Downloads 0
INFORMATION TECHNOLOGY FOR AUTOMATION OF FUZZY CONTROL WITH NON-LINEAR CONSTRAINTS
Existing information technologies of fuzzy control are based on fuzzy logic that uses the membership function of one argument and considers the control problem without constraints, covering several control variables. Fuz...
NALYSIS OF REQUIREMENTS FOR DEVELOPING THE CONTROL SYSTEM OF APPLICABLE IoT PROBLEMS
The goals and basic functions of the control systems of applied tasks of the Internet of things are defined.. The requirements to the general architecture, software and hardware of such systems was analyzed. The software...
Technical and economic aspects of the integrated systems based on electrical distribution networks
The possibility of implementing BPL technology as a technology access networks are considered. A comparative analysis of possible alternative technologies is made. Their advantages and disadvantages are clarified. Requir...
APPLICATION OF NATO STANDARDS FOR THE CREATION OF INFORMATION PROTECTION SYSTEMS IN THE AREA OF A NATIONAL SECURITY
The article analyzes the NATO standards, discusses the possible application of NATO standards in the creation and implementation of integrated information security systems at the stages of the life cycle of information s...
World indexes of introduction and use of mobile technologies.
The article describes the implementation and use of global indicators of mobile technology. The article considers the development of the mobile communications generations since the transition from the development of the...