MICROSCOPIC TRIBOLOGICAL ANALYSIS OF THE KNEE JOINT
Journal Title: Tribologia - Year 2017, Vol 273, Issue 3
Abstract
The aim of the conducted research was the evaluation of the topography and the structure of the superficial layer of meniscus and articular cartilage. These are surfaces that optimise the friction and lubrication process in the knee joint. The animal samples of the menisci and the articular cartilage were examined. The research was performed using scanning electron microscopes and an atomic force microscope. The structure of the surface of meniscus and articular cartilage is very regular. The collagenous fibres, which are embedded in the ground substance, are parallel to the surface. The undulation of the surface was observed. In the area of the anterior horn on tibia side of both menisci as well as in the anterior area of tibial plateau, the concavity and convexity pattern is evident. The observed cavities enable the accumulation of the synovial fluid. The synovial fluid plays the role of the lubricant in the knee joint, and its presence is highly desired during the load transmission.
Authors and Affiliations
Anna M. RYNIEWICZ, Andrzej RYNIEWICZ, Anna PUKALUK, Paweł PAŁKA
Keywords
Related Articles
- EP ID EP239548
- DOI -
- Views 71
- Downloads 0
PROCESSES OF TRIBOLOGICAL, CAVITATIONAL AND CORROSSIONAL WEAR OF TESTED ALUMINIUM ALLOYS APPLIED IN PLASTIC WORKING
Complex tribological processes in publications are considered as the sum of basic processes and reciprocal interactions. This produces problems with the analyses of results, because each occurring process must be analyse...
ANALYSIS OF POWER LOSSES IN THE MESHING OF A TOOTHED CYLINDRICAL GEAR LUBRICATED BY THE IMMERSION METHOD
In the paper the results of the theoretical analysis of power losses generated in the meshing of toothed cylindrical gears lubricated by the immersion method are presented. The initiations of oil in meshing were introduc...
ZNACZENIE BŁĘDÓW USTAWIENIA OPRAW ŁOŻYSKOWYCH WAŁU TRZYPODPOROWEGO DLA TRWAŁOŚCI ŁOŻYSKOWANIA
W układach napędowych maszyn i urządzeń bardzo często występują długie wały napędowe, które wymagają osadzenia na kilku podporach. Dlatego też ustalenie wpływu dokładności wykonania i montażu oraz warunków pracy łożysk n...
Model diatermiczny łożyska porowatego z dodatkowym zasilaniem olejem
Przedstawiona w pracy analiza dotyczy modelu diatermicznego łożyska porowatego pracującego w warunkach dodatkowego zasilania olejem. Podane zostały równania ruchu i energii dla szczeliny smarnej i tulei porowatej uzupełn...
WEAR MECHANISM IN PAIRING GREY CAST IRON – AL2O3 PARTICLES REINFORCED COMPOSITE
The wear mechanism of cast iron-composite material pairing was presented in this paper. Cast iron has been used for piston rings production and composite material for cylinder liners. The matrix of the composite is 6062...