Modeling and Torque Ripple Control in Faulty SPMSM
Journal Title: ANALELE UNIVERSITATII DIN CRAIOVA - Seria Inginerie electrica - Year 2016, Vol 40, Issue 40
Abstract
This paper presents a model of a Surface Permanent Magnet Synchronous Motor which can be used in a faulty case and a torque ripple control approach developed to be applied if the faulty case is detected. Two faulty cases are considered for study, the first consider an asymmetry between the stator phases of the motor created by unbalanced number of turns and the second a short circuit between the stator windings of the motor. Proposed torque ripple control use a phasor approach to provides the current reference for stator asymmetry and an injection of an inverse current for stator short circuit fault in order to decrease the motor torque ripple. The torque control has been implemented using a model of surface permanent magnet synchronous motor based on the dynamic equations. Simulation and experimental results highlight the link between the faulty and the torque ripple and show the possibility to decrease in this case the torque ripples by changing a balanced sinusoidal current reference by unbalanced one. In practical tests the impact of the unbalanced system of currents in the torque variation is studied using an analysis of vibratory harmonic measured at twice of the supply frequency.
Authors and Affiliations
Elmehdi Bahri, Remus Pusca, Raphael Romary, Driss Belkhayat
Keywords
Related Articles
- EP ID EP262625
- DOI -
- Views 133
- Downloads 0
Monitoring and Analysis of the Electrical Parameters for an Industrial Consumer using LabVIEWEnvironment
This paper presents a case study for monitoring the quality of electric energy in an industrial consumer. The measurements were carried in the power supply point where the quality of the electric energy is influenced by...
HYDRAULIC BENCH FOR ELECTRO-HYDRAULIC SERVO-VALVES AND SERVO-ACTUATORS
This paper presents a hydraulic bench for electro-hydraulic servo-valves and servo-actuators testing. This bench was realized in the laboratory of the Avionics Division of the Faculty of Electrical Engineering. For the h...
OPTIMAL SOLUTION OF WEAK SPOTS PROBLEM IN A GRID SYSTEM BY MEANS OF FACTS DEVICES
Electrical power system functioning is permanently exposed to different disturbances which cause the regime parameters change. Every grid system contains elements whose regime parameters variations influence system...
Modeling and Simulation of the Coal Flow Control System for the Longwall Scraper Conveyor
In this paper, the modeling and simulation of a coal flow control system for the longwall scraper conveyor is presented. The coal flow on the scraper conveyor, it is controlled by the following variables: the coal flow,...
Use of Modern Computing Technique to Improve the Energy Indicators of Drive Motors of the Coal Mills
In this paper, the authors present a study on the energetic opportunity to replace derated motors of the five mills which are in service at a power plant with other motors by a rated power closer to the actual load...