Modeling of the microwave phase-shifter output spectrum with effect of phase distortion
Journal Title: Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування - Year 2013, Vol 0, Issue 52
Abstract
Introduction. Nowadays, radio measuring devices began using digital phase shifters (DFS). Although they have several advantages over analog, but there are some problems faced by the developers of radio-electronic devices and systems based on them. In particular, when the frequency is translated, we have information losses contained in the frequency and amplitude. Main body. DFS that based on long transmission-lines do not have these drawbacks, but in the output spectrum of these devices we have an impact of inaccuracy phase and amplitude distortion that occurs during the formation of phase distortion. The authors have modeled the effect of phase distortion on the output spectrum of the DFS. The formula of the original spectrum was obtained as a result by authors. The spectral components at a switching frequency 16kHz and phase distortion ±5° were obtained with the software package Matlab2012a. Conclusion. The greater errors establishment of phase discrete are so much the greater array of side harmonics.
Authors and Affiliations
A. Yanenko, S. Polivkin
Keywords
Related Articles
- EP ID EP309027
- DOI 10.20535/RADAP.2013.52.52-58
- Views 92
- Downloads 0
Analysis of navigation C/A - Code of GPS system
This article the formation of S/A - Code detail its ACF and CCF, in comparison with the max length sequence and Gold-sequence. Shows the ambiguity function and its sections at different levels. Also calculated the poten...
Optimization of refraction index profile of waveguide by localization factor
The technique allowing to define refraction index profile in cross-section of singlemode waveguide with optimum value of power localization factor is offered. Waveguides with such parametres can widely be used in practic...
The phase noise of low noise transistor microwave oscillators
The phase noise direct measurement feature is analysed.
The method of calculation of the current of consumption for variating R-L loading
This article presents the methodology for the calculation of the current of consumption in case of variating loading with analytical equations
Noise-immunity processing of digital multilevel pulse-amplitude modulation signals
Introduction. The main properties and features of spectral-effective multi-level pulse amplitude modulation digital signals at coherent reception are presented. It is shown that the phase locked loop circuit (PLL) circui...