Modification of the surfaces of wood cutting tools using CO2 laser - SEM analysis
Journal Title: Annals of WULS, Forestry and Wood Technology; Zeszyty naukowe SGGW - Year 2017, Vol 98, Issue
Abstract
Modification of the surfaces of wood cutting tools using CO2 laser - SEM analysis. SEM analysis of the surfaces of wood cutting tools modified by CO2 laser is presented. The aim of the conducted research was to study the influence of CO2 laser beam on surface topography of WC-Co cutting edges used in wood based material machining. There images obtained on SEM as well as cutting edge spallings, scratches and cracks on the surface subjected to modification are revealed.
Authors and Affiliations
Paweł Kołodziejczak, Jacek Wilkowski, Marek Barlak, Zbigniew Werner, Jerzy Zagórski
Water jet cutting waterproof foliated plywood
Water jet cutting waterproof foliated plywood. This paper focuses on the use of unconventional technologies for water jet cutting beam foliated waterproof plywood material. The following are the results of the experiment...
Formability of radial and tangential beech veneers
Formability radial and tangential beech veneers. The paper deals with the evaluation of 3D formability of radial and tangential veneers produced from beech (Fagus sylvatica L.). 3D formability was determined the method b...
Реологические свойства низкотоварной древесины сосны
Rheological properties of low marketable pine wood. The article provides some results of experimental studies to determine the modulus of elasticity and rheological coefficients of compression along the grain of pine woo...
Neuheit beim Profilieren im Sägewerk
Neuheit beim Profilieren im Sägewerk. In diesem Referat wird eine Neuheit aus dem Sägewerksbereich dargestellt. Der deutsche Werkzeugspezialist Leuco und der deutscher Sägewerksmaschinenhersteller EWD haben in Kooperati...
Adhesion of foils to MDF board
Adhesion of foils to MDF board. The article deals with adhesion of foils to MDF board. Foiled furniture parts made from MDF board are one of the alternatives of coating. The aim of our work was to study the effect of adh...