Multi-Objective Optimization of MQLC Turning Process Parameters Using Grey-Fuzzy Approach
Journal Title: Mašinstvo - Year 2019, Vol 16, Issue 1
Abstract
In this paper the influence of different machining parameters on the surface roughness, cutting force and material removal rate during turning process using MQLC (minimum quantity lubrication and cooling) system was investigated. The experimental plan was defined using Taguchi’s method. Orthogonal array L9 (34) was selected for four input parameters varied on three levels. Parameters that were varied in experiments are: cutting speed (vc), depth of cut (ap), feed rate (f) as well as workpiece steel material. The grey relational analysis in combination with fuzzy logic technique was used to find out the input parameters levels that lead to optimal process responses values.
Authors and Affiliations
Mario Dragičević, Edin Begović, Ivan Peko
Keywords
Related Articles
- EP ID EP587939
- DOI -
- Views 56
- Downloads 0
The Procedure of Establishing Micro Plant of Renewable Energy Sources and the Profitability
This paper describes the procedure of opening a micro plant for renewable energy sources in Bosnia and Herzegovina, from the idea to the realization of the project, where the steps and acts of obtaining specific document...
Analysis Solution of Cut Using Methods of Reinforced Wall, Soil Nailing and Making Retaining Wall
The paper describes analyses solution of cut in the highway. There have been used three methods of making construction: reinforced wall with HDPE geogrids, soil nailing and retaining wall 20 meters long. AASHTO standards...
Application of Compressed Air in Pit “Haljinići”, JP EP BiH D.D. - Sarajevo, ZD RMU ”Kakanj” d.o.o. Kakanj
During analysis of main problems in the pit "Haljinići", the drive energy represents one of the most important phases of the operation for functioning of the section, so imying and solving problems related to this segmen...
Calculation Index of Reliability on the Example of Steel Hall, Comparation of PTP and EC-1 Regulations for Snow Load
This paper deals with the resistance of the shed of a steel hall in Drvar according to technical regulations for snow from 1961 and EC1 regulations. The paper aims to check the reliability of the shed with probabilistic...
How to Determine the Cause and Source of Hydraulic Oil Varnishing
While performing ordinary oil condition monitoring on industrial systems, we can often notice that hydraulic oil has changed its color. The source of the problem can be very difficult to locate and is often consequence o...