A STUDY OF PORTAL FRAME USING ANALYTICAL METHODS AND ETABS SOFTWARE
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 5, Issue 3
Abstract
Analysis of portal frames involves lot of complications and tedious calculations by conventional methods. To carry out such analysis is a time consuming task. The Moment Distribution Method & Slope Deflection Method for analysis of portal frames can be handy in approximate and quick analysis so as to get the detailed estimates ready. In this work, these two methods have been applied only for vertical loading conditions. This paper mainly deals with the comparative analysis of the results obtained from the analysis of single bay portal frame when analyzed manually and using ETABS Software separately. The result obtained from manually is mostly matched with the results obtained from ETABS software.
Authors and Affiliations
R. H. Mohankar
Keywords
Related Articles
- EP ID EP106858
- DOI 10.5281/zenodo.48372
- Views 91
- Downloads 0
CYCLE TIME REDUCTION THROUGH MINIMIZATION OF TRANSPORTATION AT A PALLET MANUFACTURING COMPANY IN THE PHILIPPINES
In the pursuit of profitability and competitiveness, more companies are turning to lean manufacturing to reduce or eliminate waste in their production processes. Cycle Time Reduction to increase productivity was t...
DETECTION OF CLONE NODE USING CHORD ALGORITHM FOR SECURE DATA TRANSMISSION AND PREVENTION OF COLLUSION ATTACKS IN WSN
At present due to limitation and computing power and energy resources of sensor node the data is aggregated by extremely simple algorithm such as averaging data from multiple sensors is aggregated at aggregation n...
Implementation of AHB Bus Tracer with Compression and Multi Resolution for SOC
In the system-on-chip (SOC) debugging and performance analysis/optimization, monitoring the on-chip bus signals are necessary. But, such signals are difficult to observe since they are deeply embedded in a SOC and...
INVERTERS CURRENT FREQUENCY DEVIATION BASED ISLANDING DETECTION IN GRID CONNECTED PHOTOVOLTAIC SYSTEM
The protection schemes of distribution systems are usually designed under the assumption that power flows from the substations to the end users.The utility system contains both load and generation in which part of...
DAMAGE ANALYSIS OF DEGRADED SLITTING KNIFE
This study analyzed the damage to a slitting knife after cutting steel sheets. Damages to the structure were observed and wear tests were conducted. In addition, the degradation on the damaged and undamaged parts w...