Automatic Irrigation System using WSNs
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 3, Issue 6
Abstract
During the entire, I went through various electronics equipment for the project. I learned about Controller 8051, Contact type sensors, Comparator and a little about other electrical equipments. Irrigation systems are as old as man itself since agriculture is the foremost occupation of civilized humanity. To irrigate large areas of plants is an onerous job. In order to overcome this problem many irrigation scheduling techniques have been developed which are mainly based on monitoring the soil, crop and weather conditions. Irrigation scheduling engrosses when to irrigate and how much water to be applied. Currently most of the irrigation scheduling systems and their corresponding automated hardware are fixed rate. Variable rate irrigation is very essential not only for the improvement of irrigation system but also to reduce the irrigation cost and to increase crop yield. The heart of automatic irrigation system (fixed rate or variable rate) is its control unit: as it controls irrigation time and water flow.
Authors and Affiliations
Ravinder Singh Dhanoa1
Keywords
Related Articles
- EP ID EP148393
- DOI -
- Views 61
- Downloads 0
TO DEDUCTION OF MASS FLOW RATE FOR HELICAL HEAT EXCHANGER AT MULTIPLE CROSS-SECTIONS USING CFD
Enhancing the heat transfer by the use of helical coils has been studied and researched by many researchers, because the fluid dynamics inside the pipes of a helical coil heat exchanger offer certain advantages ove...
Power Efficient Viterbi Decoder
Error correction is an integral part of any communication system and for this purpose, the convolution codes are widely used as forward error correction codes and for their decoding at the receiver end viterbi decoders...
Numerical Prediction of Weld Quality in Friction Stir Welding of Dissimilar Materials
Objective of this research is to develop a finite element simulation of friction stir welding of Magnesium and Titanium alloys. In the present study, the transient analysis is performed in Ansys to simulate the fr...
On the Assessment of Solid and Hazardous Waste Management in Port Harcourt, Nigeria
This study examines the management of both solid and hazardous waste constituents in Port Harcourt, Nigeria. For this purpose, the study area was divided into four zones and were further classified into low, mediu...
Assessment And Comparison of Thermal fatigue Failure For BS 3059 Boiler Tube
This research highlights on the assessment of thermal fatigue failure for BS 3059/1087 Part 1 ERW 320 boiler tube using experimental procedure by using of smithy furnace and comparing with Coffin are highly affec...