Effects of Adding Alcohols, Electrolytes and Carboxyl Methyl Cellulose (CMC) on Design Parameters in Internal Loop Airlift Bubble Column

Abstract

 The effect of gas velocity, liquid-phase properties, solid-particle concentration and the static liquid height on gas hold-up (ɛg) and mass transfer coefficient (KLa) were studied in a three phase internal loop airlift bubble column (ILBC) (the ratio of the draft tube to column diameter equal to 0.5). Air was used as a gas phase. Water and seven aqueous solutions of 10% concentration methanol, ethanol, NaCL, acetic acid, 50% glycerol and 2%CMC were used as the liquid phase. Polyethylene-non-porous-solid particles with a concentration of (50,100) Kg/m3 were used as solid phase. Superficial gas velocity varied from 0.01 m/s to 0.1 m/s and air dispersed into the center of the draught tube by using a porous gas distributor. The results showed that (εg) and (KLa) increase with increasing gas velocity and decrease with increasing solid particle concentration, static liquid height, viscosity and surface tension of liquid-phase.

Authors and Affiliations

Ali Abdul Rahman –Al Ezzi

Keywords

Related Articles

ANALYSIS OF REACTIVE POWER ON DIFFERENT BUSES OF A 57-BUS POWER SYSTEM

With the help of Load flow study all the power flow parameters can be find out of power system network .However so many methods are available to solve the load flow problems but accuracy and speed are the main problems...

 SAFETY ANALYSIS AND RISK ASSESSMENT FOR BRIDGES HEALTH MONITORING WITH MONTE CARLO METHODS

 With the increasing requirements of building safety in the past few decades, healthy monitoring and risk assessment of structures is of more and more importance. Especially since traffic loads are heavier, risk Ass...

SSSC WITH POD CONTROLLER FOR REACTIVE POWER COMPENSATION IN INDUCTION GENERATORS

One of the main problems faced by the Induction generator during fault is voltage sag. This phenomenon is really an undesirable one. The main aim is to introduce SSSC as a solution for this problem. It is connected in se...

 IMPLEMENTATION OF POWER EFFICIENT PROGRAMMABLE PRPG USINGBS-LFSR BASED ON BIST

 This paper describes a low-power programmable generator with bit swapping technique which is capable ofproducing pseudorandom test patterns with toggle selection(TOSE) , enhanced fault coverage and poweroptimizatio...

REVIEW PAPER ON PERFORMANCE EVALUATION OF DISTILLERY PLANT THROUGH ENERGY CONSERVATION METHODS

India is amongst two largest sugar producing countries in the world and fourth largest producer of ethanol in the world and second largest in Asia. India produces about 2.75 billion liters alcohol annually. Many perviou...

Download PDF file
  • EP ID EP117286
  • DOI -
  • Views 63
  • Downloads 0

How To Cite

Ali Abdul Rahman –Al Ezzi (30).  Effects of Adding Alcohols, Electrolytes and Carboxyl Methyl Cellulose (CMC) on Design Parameters in Internal Loop Airlift Bubble Column. International Journal of Engineering Sciences & Research Technology, 2(12), 3415-3426. https://europub.co.uk/articles/-A-117286