Finite Element Analysis of Helical Gear Using Three-Dimensional Cad Model
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 3, Issue 4
Abstract
Gears are one of the most critical components in mechanical power transmission systems. The bending and surface strength of the gear tooth are considered to be one of the main contributors for the failure of the gear in a gear set. Thus, analysis of stresses has become popular as an area of research on gears to minimize or to reduce the failures and for optimal design of gears. This paper investigates finite element model for monitoring the stresses induced of tooth flank, tooth fillet during meshing of gears. The involute profile of helical gear has been modeled and the simulation is carried out for the bending and contact stresses and the same have been estimated. To estimate bending and contact stresses, 3D models are generated by modeling software CATIA V5 and simulation is done by finite element software package ANSYS 14.0. Analytical method of calculating gear bending stresses uses Lewis and AGMA bending equation. For contact stresses Hertz and AGMA contact equation are used. Study is conducted by varying the face width to find its effect on the bending stress of helical gear. It is therefore observed that the maximum bending stress decreases with increasing face width. The stresses found from ANSYS results are compared with those from theoretical and AGMA values.
Authors and Affiliations
Babita Vishwakarma*1
Keywords
Related Articles
- EP ID EP153537
- DOI -
- Views 57
- Downloads 0
ASSESSMENT OF FIRE AFFECTED CONCRETE STRUCTURE BY NDT- A CASE STUDY
is paper is an attempt to perform various Non-Destructive Tests on concrete structures. Various tests that are performed under NDT not only enable us to determine the strength of concrete structure, but also provi...
DISEASE DETECTION ON COTTON LEAVES AND ITS POSSIBLE SOLUTIONS
The application takes image as input and gives the related information about the disease and its possible diagnosis. Image analysis is one important method that helps segment image into objects and background. Con...
Surge Detection System for Centrifugal Compressor
Problem: The turbo compressor Surge is an unstable operating mode of compression system that occurs at mass flows below the so-called surge line. The instability is characterized by large limit cycle oscillations...
Detection of Low Vision with the help of Segmented Retinal Images
Retinal Blood Vessel segmentation is much required for detecting the cardiovascular diseases like ophthalmic pathologies, hypertension etc. The available techniques not having the features like measuring the indi...
FINISHING OF STEELS THROUGH HYDRAULICS
For finishing area of MMSM department of VSP, The 5/2 CELLAR HYDRAULIC SYSTEM is having two units (LHS and RHS) separating pressurized oil of 100 bar to all hydraulic operated equipments in both sections (LHS and...