GEOMETRICAL NONLINEAR ANALYSIS OF COMPOSITE PLATE
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 5, Issue 3
Abstract
The application of piezoelectric actuators for static shape control composite plate is investigated in this thesis. Electromechanically coupled mathematical model is used for the analysis. The major section of this thesis is the static shape control. Shape control is defined here as the determination of shape control parameters, including actuation voltage and actuator orientation configuration, such that the structure that is activated using these parameters will conform as close as possible to the desired shape. A finite element model for shape control analysis of piezoelectric laminated composite plate using Ansys is presented in this thesis. Piezoelectric actuators and sensors are modeled as additional layers either to be surface bonded or embedded in the laminated composite plate. A finite element software Ansys is used to model and was successfully validated with experimental and numerical results that are readily available in the literatures. The present analysis shows that with the application of appropriate voltage to piezoelectric actuator, desired shape of the composite plate can be obtained.
Authors and Affiliations
Sangamesh B. Herakal
Keywords
Related Articles
- EP ID EP117703
- DOI 10.5281/zenodo.47028
- Views 79
- Downloads 0
PROPERTIES OF CONCRETE WITH RED MUD AS PARTIAL REPLACEMENT OF CEMENT WITH HYDRATED LIME AND SUPERPLASTICIZER
In this research an attempt has been made to produce different grades of concrete using huge industrial waste such as red mud as a partial replacement of cement with the hydrated lime. This project presents the results...
Performance of Capacitor Supported SRF based DSTATCOM in Three-Phase Four-Wire Distribution System under Linear and Non-Linear Load Condition
In this paper, the four-leg voltage source converter (VSC) with capacitor in its parallel, was functioned as a distribution static compensator (DSTATCOM). In three-phase four-wire distribution system, DSTATCOM was...
Design of Modified Booth Multiplier using Reversible gate logic for Radix-8
This paper describes the concept of multiplication by using modified booth algorithm and reversible logic functions for radix-8. By using Modified booth algorithm, less delay is produced compared to normal multip...
ROLE OF PHOTOSENSITIZER (ORANGE-G) IN PHOTOGALVANIC CELL FOR GENERATION OF SOLAR ENERGY
The Orange-G is used as photo sensitizer with EDTA as reductant for the enhancement of the conversion efficiency and storage capacity of photo galvanic cell for its commercial viability. The observed value of the...
Malicious Codes in Mobile Phones
In this paper a survey study is made on various issues of mobile malicious codes. Spreading pattern of different mobile viruses is discussed to make a collective analysis of concerned problem and various approache...