Improving Distribution Feeders for Photovoltaic Generation by Loop Power Control Method
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2014, Vol 4, Issue 2
Abstract
Now a day’s solar power plants are more reliable, because no fuel and reduced CO2 emission. But the solar power generation system do not work in all weather conditions, it is power generated only solar radiation time .To overcome this problem by using (pv)). In fuel cell power generation there will be no problems, where as in fuel cell power distribution systems have some problems like overloading the distribution feeders. In this project to overcome this overloading by using Loop Power Controller (LPC).The loop power controller to control real power and reactive power flow by adjusting voltage ratio and phase shift. Daily loading unbalance is determined by analyzing (pv) power generation recording by using SCADA system and load profile based on Data Automation System (DAS).The loop power controller can improve controllability, operational flexibility and reduce power loss of the distribution system. The Loop Power Controller (LPC) is based on the MATLAB/ SIMULINK
Authors and Affiliations
Husam Saad Abdulla
Keywords
Related Articles
- EP ID EP104823
- DOI -
- Views 114
- Downloads 0
Lossy Transmission Lines Terminated by Parallel Connected RC-Loads and in Series Connected L-Load (I)
Abstract: The present paper is the first part of investigations devoted to analysis of lossy transmission lines terminated by nonlinear parallel connected GC loads and in series connected L-load (cf. Fig. 1). First...
Design And Analysis Of Precast Load Bearing Walls For Multi Storey Building Using Etabs
In the present scenario of construction industry, time of construction is very crucial factor. Pre-cast construction is gaining significance in general and urban areas in particular. The precast technology is a via...
A Case study for near net Shape – Flashless forging for full yoke (Sleeve Yoke OMNI)
Forging is a metal forming process commonly used in industry. Forging process is strongly affected by the process parameters. In a progressive press forging process, an initial block of metal (billet) is compressed b...
Optimization of Factors Affecting Glucuronic Acid Production in Yogurt Fermentation
Drinking yogurt fermentation with two bacteria strains Lactobacillus acidophilus and Gluconacetobacter nataicola was optimized to get maximal glucuronic acid concentration. A Blackett –Burman matrix was designed to...
Experimental Comparison Study for Savonius Wind Turbine of Two & Three Blades At Low Wind Speed
In this project, experimental comparison and investigations were carried out to study the performance and to make a comparison between two and three blades Savonius wind turbine. For this purpose, two models of two...