Selection of Cutting Tool Insert in Turning of EN 8 Steel using Multiple Attribute Decision Making (MADM) Methods
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 3, Issue 12
Abstract
A surface finish is very important in turning process. The main objective of this paper is to select a right cutting tool insert from amongst a number of cutting tool inserts during turning of EN 8 steel work piece with good surface finish.In present study number of inserts are five.So it is difficult to select the one best insert amongst five cutting tool inserts. Multiple Attribute Decision Making (MADM) methods provide a ranking of the available alternatives thereby, decision of critical thinking become easier. Hence in this paper a logical procedure used to select best tool insert from alternative tool inserts for better surface finish in turning operation. The procedure based on two well known Multiple Attribute Decision Making (MADM) methods such as Simple Additive Weighting (SAW) and Weighted Product Method (WPM). A tool insert selection index is proposed that evaluates and ranks of tool insert for good surface finish in turning operation.Finally from ranking select the best tool insert for better surface quality
Authors and Affiliations
K. G. Nikam
Keywords
Related Articles
- EP ID EP138062
- DOI -
- Views 63
- Downloads 0
REVIEW ON “POKA-YOKE: TECHNIQUE TO PREVENT DEFECTS”
In today’s competitive world any organization has to manufacture high quality, defect free products at optimum cost. The new culture of total quality management, total productive management in the manufacturing as...
SIMPLEST PHASE NOISE MITIGATION TECHNIQUE IN OFDM SYSTEM
In Orthogonal Frequency Division Multiplexing Communication systems, the local oscillator used for the upconversion and down-conversion at the transmitter and receiver respectively introduces phase noise which cau...
Conversion of Thermal Energy to Electrical Energy using NTC
The basic aim of this paper is to depict the process by which temperature changes in the resistance of NTC can reflect in the output voltage which further can be used to produce various range of voltages. The outp...
REVIEW ON TURBOCHA RGING OF IC ENGINES
As a demand of new efficient and eco friendly engines is increasing new technologies are developing. Due to rich air fuel mixture combustion emissions will be increased hence by turbocharging the engine...
ADAPTIVE NOISE CANCELLATION TECHNIQUE USING LMS,RLS AND WAVELET TRANSFORM
This paper describes the concept of adaptive noise cancelling (ADC), in alternative scheme of estimating signals corrupted by additive noise or interference. The main objective of the noise cancellation is to esti...