SISO MMSE-PIC detector in MIMO-OFDM systems
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2013, Vol 3, Issue 5
Abstract
MIMO-OFDM with bit-interleaved coded modulation (BICM) is an attractive technique for wireless communications over frequency selective fading channels which has gained significant interests as a promising candidate for the 4th Generation wireless communication. The SISO MMSE-PIC based detector is proposed in this paper. The SISO MMSE-PIC detector exchanges soft information with SISO channel decoder through iterative process. For reduction complexity, the Max Log MAP approximations decoder is exploited for iterative BICM decoding of MIMO-OFDM under perfect channel knowledge. Simulation results in the IEEE 802.11 channel model show that the SISO MMSE-PIC iterative detector decoder leads to a clear improvement of the performance than the SISO ZF-PIC based detector with saturation at 4th iterations. For a large number of iterations, the performance improvement is not significant which could be investigated for practical reduction complexity considerations. Furthermore, for a 10−2 bit error rate BER target, the gain in the performance of the SISO MMSE-PIC is approximately about 3dB when the number of antennas is twice. The performance of the SISO MMSE-PIC under different modulation schemes for MIMO-OFDM systems shows that with lower modulation size, the method can perform better and decreases when the channel delay spreads is increased.
Authors and Affiliations
A. Bensaad
Keywords
Related Articles
- EP ID EP130962
- DOI -
- Views 108
- Downloads 0
A Novel High Performance H-Bridge Converter Topology for 8/6 pole SRM Drive
Despite of the fact that obviously less complex, the SRM drives are these days more expensive than their formal AC drive systems. This is, all things considered brought about by the absence of an optimal power...
Energy Consumption and Distribution
For as long as the global economy continues to operate on the basis of the limited energy and material supplies, its future prospects will be bleak. There are two incontrovertible reasons for this. Firstly, suppl...
Modeling and Optimization of Wire EDM Process
The present work is aimed to optimize the parameters of (WEDM) process by considering the effect of input parameters viz. Time On, Time Off, Wire Speed & Wire Feed. Experiments have been conducted with these pa...
Effect of Preform Geometry on the Material Behaviour and the Densification Mechanism during Hot Upset Forging of Sintered AISI 9840 P/M Steel Produced Using Elemental Powders
The present investigation pertains to generate experimental data in order to establish the influence of initial preform geometries on the material behaviour and the operative densification mechanism/s during ho...
Comparison of Conventional and “Satlevel” Collocation Model for Production of Contour Map of Yanbu Industrial City
Contour map is very useful as its portrays the three dimensional (3D) configuration of the area under study. Data acquisition by conventional method of production of such maps has been very tedious. There is need for sim...