Neural Network Modeling of Cutting Fluid Impact on Energy Consumption during Turning
Journal Title: Tribology in Industry - Year 2016, Vol 38, Issue 2
Abstract
This paper presents a part of research on power consumption differences between various cutting fluids used during turning operations. An attempt was made to study the possibility of artificial neural network to model the behavior function and predicting the electrical power consumption. Friction factor of examined cutting fluids was also measured to describe a more complete picture of investigated cutting fluids characteristics. It was discovered that wide spectrum of characteristics is present in today’s market and that artificial neural networks are suitable for purpose of modeling the power consumption of the lathe during machining. This paper could be used as a foundation for later database building where it would be possible to predict how certain cutting fluid will behave in a specific machining parameter combination.
Authors and Affiliations
M. Bachraty , M. Tolnay , P. Kovac , V. Pucovsky
Keywords
Related Articles
- EP ID EP164620
- DOI -
- Views 81
- Downloads 0
Wear-resistance of Aluminum Matrix Microcomposite Materials
A procedure is developed for the study of wear of aluminum alloys AlSi7 obtained by casting, reinforced by TiC microparticles, before and after heat treatment. Tribological study is realized under conditions of friction...
Development of Aplication for Analysis of Machinability Index
Rapid development of new materials, cutting tools and cutting fluids promote research of machinability for new materials and tribological characteristic of cutting tools and cutting fluids. Material machinability is very...
Analysis of Three Body Abrasive Wear Behaviour of Centrifugally Cast Aluminium Composite Reinforced with Ni Coated SiC using Taguchi Technique
The aim of the present research is to determine the abrasive wear behavior of functionally graded Al LM21/10wt.% Ni coated SiC composite fabricated by centrifugal casting route. The centrifugal cast hollow cylindrical pa...
Effect of Different Fillers on Adhesive Wear Properties of Glass Fiber Reinforced Polyester Composites
Polymeric composites are used for different aims as substitute of traditional materials such as metals; due to their improved strength at small specific weight. The fiber reinforced polymer (FRP) composite material consi...
Evaluation of the Wear-Corrosion Process in Beta-Tricalcium (β-TCP) Films Obtained by Physical Vapor Deposition (PVD)
A simultaneous evaluation was done of the wear-corrosion of the coatings of beta-tricalcium phosphate on titanium (Ti) substrate deposits obtained by the magnetron sputtering technique. The characterization was developed...