Оптимальне розташування вирівнювальної пластини в конструкції дифузора для підвищення тискових та витратних характеристик вентиляційних систем
Journal Title: Вісник Національного університету "Львівська політехніка". Серія "Теорія та практика будівництва" - Year 2016, Vol 0, Issue 844
Abstract
At work investigates the incoming flow and its alignment to the ventilation system elements, located directly outside a radial fan. The efficiency of the ventilation system depends on the improvement of its aerodynamic components. Of great importance are placed the elements directly outside a radial fan. The attention paid to the improvement in work mode energy efficiency of ventilation systems alignment the incoming flow of radial fan the variable modes of its work. In the article experimental studies determined the optimal location of the line-up plate in the design of the diffuser to improve the characteristics of pressure and supplies ventilation systems. These studies carried out depending on the distance from the location of line-up plate side wraps fan and hollow plate in the fan casing outlet, increasing its relative length. The research results can be used to improve the energy efficiency of ventilation systems with radial fans. An effective means of improving the performance of air and pressure in ventilation systems, improving their structural elements situated after the discharge pipe radial fan. The dependencies impact location leveling plate in the diffuser attached directly to the radial fan to change the aerodynamic characteristics of the ventilation system
Authors and Affiliations
B. Gulay, H. Myronyuk, O. Omelchuk, V. Shepitchak
Keywords
Related Articles
- EP ID EP230208
- DOI -
- Views 101
- Downloads 0
ЕКСПЕРИМЕНТАЛЬНІ ДОСЛІДЖЕННЯ ДЕФОРМАТИВНОСТІ І МІЦНОСТІ ПОПЕРЕДНЬО НАПРУЖЕНОЇ ЗБІРНО-МОНОЛІТНОЇ БАЛКИ ПРОГОНОВОЇ БУДОВИ ПРОЛЬОТОМ 12 М
The paper presents only some problems of design and constraction of the bridge. The active provides the results of the research out composite muilti-span prestressed reinforced concrete beam for time building bridges. Co...
ВИРОБНИЦТВО, ВЛАСТИВОСТІ І ЗАСТОСУВАННЯ ГАЗОБЕТОНУ НЕАВТОКЛАВНОГО ТВЕРДНЕННЯ
One of the priorities of modern construction industry is to increase the heat-shielding properties enclosing structures and reduce construction costs. Solving these problems is possible through the use in the manufacture...
Investigation of air flow in a twin roofs of residential houses
Some kinds of flat roofs with low height of ventilated air gap have certain problems with thermal and moisture regime. The lower surface temperatures of internal constructions in the air gap of roof and presence of hot a...
Wind action on the building faсade and Its influence on ventilation heat losses
A significant factor affecting of indoor climate and energy consumption in buildings is the air exchange rate. In correlation method is used mostly stationary outdoor climatic conditions specified in the standards - cons...
USING IMPROVED DESIGN METHOD OF SHEER STRENGTH OF REINFORCED CONCRETE BEAMS
The analysis of the efficiency of six types of slabs has been carried out, which differed in material, internal form and weight. The comparison and the comparison of the same in size, but different in constructive char...