Optimization Design of Independent Photovoltaic Power System
Journal Title: Architecture and Design Review - Year 2019, Vol 1, Issue 1
Abstract
Solar energy as a huge amount of renewable energy, the daily arrival of the earth's surface radiation energy equivalent to hundreds of millions of barrels of oil burning energy. Development and use of rich, vast solar energy, cannot produce or produce little pollution to the environment, solar energy is both the urgent need for future energy supplement, but also the basis of future energy structure. However, because the traditional do not pay much attention to the collocation of PV modules, resulting in a lot of waste, this paper presents a new optimization design method for the shortcomings of the previous system design methods. This paper summarizes the composition and operation of the PV system, and discusses the establishment of the mathematical model of each part. Including the solar radiation resource model, the best tilt model of the solar cell matrix, the solar cell square power generation model, the battery status model, the load model. On the basis of this, the paper takes the minimum energy loss of PV system as the principle, and studies the problem of maximum power point tracking and the selection of inverter circuit, which has certain practical application value.
Authors and Affiliations
Jinghong Chen,Hongsheng Xu,Qiongfang Xie
Keywords
Related Articles
- EP ID EP680133
- DOI -
- Views 205
- Downloads 0
Cultural Symbols in Chinese Architecture
Culture has been recognized as the fourth pillar of sustainable development, and culture is often viewed as a system of symbols that arises from human interpretations of the world. The cultural codes of symbols and symbo...
Evaluation of Residual Strength of RC Columns in Fire-Damaged Buildings: Case Study
Prediction of residual strength of structural members in a RC fire-damaged building is an important step in taking a decision about restoration or demolition of the building. In this paper a finite element model was deve...
3D Indoor Modelling Using UAV’s Video
3D indoor modelling is a digital representation of the interior space in building to ensure the indoor space is in a good quality condition. The aim of this study is to assess UAV’s video for 3D indoor modelling. The met...
Marine Corrosion of Steel with Aerobic and Anaerobic Biofilms under Changeable Nutrient Concentration Conditions
A diffusional model of marine corrosion wear for steel structures is developed and presented in this work, based on the assumption that long-term corrosion depends on both aerobic and anaerobic bacterial activity, which...
Treatment of Common Technical Problems in Roof Construction
Roof waterproof engineering is an important part of architectural engineering, waterproof engineering quality is good or bad, a direct impact on the life of buildings and structures, affecting people’s normal life order....