Abstract

With passage of time technologically advanced machines have been developed. But the problem of the tool wear and cutting force for a particular machining process remains to be improved. So, to avoid or to cope-up with this problem it is necessary to find the best combination of machining parameters for obtaining optimum cutting force. In this work the optimization of cutting force for a given combination is done in a useful and easy way. Three factors are selected that affect the optimizing parameters in case of turning. These factors are optimized to get the optimum cutting force. This is achieved by employing response surface methodology and signal to noise ratio calculation. One factor is varied by keeping the other two constant at same range. Through the response surface methodology 2D and 3D graphs are obtained and optimization is achieved. The S/N ratio is done to find out which factor has the most influence on the output that is cutting force. Arpita Saha | Dr. Sudip Mukherjee"Optimization of cutting force of turning of AISI 1018 mild carbon steel using RSM" Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-2 | Issue-3 , April 2018, URL: http://www.ijtsrd.com/papers/ijtsrd11701.pdf http://www.ijtsrd.com/engineering/mechanical-engineering/11701/optimization-of-cutting-force-of-turning-of-aisi-1018-mild-carbon-steel-using-rsm/arpita-saha

Authors and Affiliations