Optimization of Process Parameters on Thrust Force and Delamination Factor in Drilling of Carbon Fiber Reinforced Composites
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 2
Abstract
The major objective of this work was to investigate a statistical model, based on Taguchi technique and to estimate the quality of drill in CFRP composite material prepared by hand layup technique. The design of experiments were made to investigate the influence of drill parameters such as cutting speed, feed rate and drill diameter on thrust force and delamination factor in drilling of CFRP laminates. Analysis of variance (ANOVA) was used to analyze the significance level of every drill parameters. The statistical model yields the results showing that the speed and feed rate were the major parameters affecting significantly the drilling process. Delamination due to drilling was analyzed by the stereomicroscope.
Authors and Affiliations
Keywords
Related Articles
- EP ID EP347404
- DOI 10.24247/ijmperdapr201866
- Views 81
- Downloads 0
A Study on the Effects of Heat Treatment on the Mechanical Properties of Aluminium Alloy (ADC 12) Reinforced With Iron Oxide (FE2O3)
The mechanical properties of an Al–Si–Cu alloy (ADC12) reinforced with iron oxide, produced using different Heat treatment to process is examined experimentally. Experimental studies were carried out for ADC 12, ADC 12 +...
Comparison of Various Models Implemented Using Linear and Non-Linear System Identification Methods for Cement Grinding Process Using Vertical Roller Mill
Vertical Roller Mill (VRM) has been promptly employed and extensively used for clinker and cement grinding for past 35 years, because of its higher efficiency and low power consumption. VRM is a highly nonlinear, time de...
Solar Still Efficiency Augmentation using Cylindrical Sweeping Agitator on the Absorber Plate
Passive solar stills are simple devices which generate potable water by way of desalination of brackish water. However, the main limitation of this device is its poor still efficiency. This paper presents an innovative t...
Waste Pyrolysis Tire Oil as Alternative fuel for Diesel Engines
Today, India is facing two biggest problems, one is the depletion of the fossil fuel reservoir and the other is the pollution. These two problems motivated us, as well as many other researchers, to work on the utilizatio...
The Numerical Simulation and Evaluation of Aircraft Engine Axial Flow Turbine using Numerical Techniques
This research aims to improve the efficiency of an axial flow turbine by improving the boundary conditions. In the baseline paper, Sherwood number, Nusselts number for a given flow were determined. The pressure ratio was...