Parameter estimation method for induction machines using instantaneous voltage and current measurements
Journal Title: Revista Facultad de Ingeniería-Universidad de Antioquia - Year 2015, Vol 1, Issue 75
Abstract
This paper proposes an off-line method to determine the electrical parameters of an induction machine based on two instantaneous indicators (impedance and power). The method uses the induction machine start-up voltage and current measurements. Also, the proposed method employs a space vector dynamic model of the induction machine referred to the fixed stator reference frame. This model allows the representation of the instantaneous indicators in terms of the machine electrical parameters. An error function is defined using the indicators obtained from the measurements, versus the corresponding derived from the dynamic model of the machine. The estimated parameters are obtained by minimizing this error function by means of a constrained nonlinear optimization algorithm. The effectiveness of the proposed method was experimentally validated. The results from the model using the estimated parameters fit the experimental data sets with average error below 5%.
Authors and Affiliations
Johnny Wladimir Rengifo-Santana, Joseph Benzaquen-Suñe, Jose Manuel Aller-Castro, Alexander Alfredo Bueno-Montilla, José Restrepo-Zambrano
Keywords
Related Articles
- EP ID EP626912
- DOI 10.17533/udea.redin.n75a07
- Views 102
- Downloads 0
Influence of meteorology and source variation on airborne Pm10 levels in a high relief tropical Andean city
Atmospheric particulate matter (PM10) was evaluated with meteorology, mixing height and source variation over a two year period (January 2010 to December 2012) in the densely populated tropical Andean city of Manizales....
Simulating gas-liquid mass transfer in a spin filter bioreactor
Computational fluid dynamics (CFD) and population balance model (PBM) model have been used to simulate hydrodynamics and mass transfer in a 0.014 m3 Spin Filter Bioreactor. The operating conditions chosen were defined by...
Imputation of spatial air quality data using gis-spline and the index of agreement in sparse urban monitoring networks
This paper presents a procedure to address the lack of spatial air quality data in urban areas, based on the use of Geographic Information Systems (GIS) and spatial interpolation techniques as an alternative to conventio...
Assessment of the RLS 90 calculation method for predicting road traffic noise in Colombian conditions
This paper presents an evaluation of the German standard RLS 90 (Richtlinien für den Lärmschutz an Straben) for the estimation of noise levels produced by the traffic flow in Colombian conditions. For this, environmental...
Physical and mechanical characterization of concrete exposed to elevated temperatures by using ultrasonic pulse velocity
Experimental investigations were carried out for assessing the influence of thermal loadings on the physical and mechanical properties of plain concrete after fire exposure. Cylindrical specimens were subjected to therma...