PARAMETRIC ANALYSIS FOR THE DESIGN OF A 4 POLE RADIAL PERMANENT MAGNET GENERATOR FOR SMALL WIND TURBINES
Journal Title: Power Electronics and Drives - Year 2016, Vol 2, Issue 2
Abstract
Background: A review of the literature gives some guidelines for the design of a Permanent Magnet Synchronous Generator (PMSG). Material and methods: In this work a deeper analysis of the available topologies applied to a 3 phase radial flux generator for Small Wind Turbines (SWT) is discussed. Some parametric finite element analysis and simulation are compared for design purposes. Results: Crucial values obtained for the direct drive SWT design-criteria are presented. Conclusions: Finally, a discussion of the results in comparison with the literature is presented as a step towards design optimization.
Authors and Affiliations
Roberto Eduardo-Palomo, Maciej Gwoździewicz, Mateusz Dybkowski
Keywords
Related Articles
- EP ID EP175063
- DOI -
- Views 66
- Downloads 0
DIRECT FIELD-ORIENTED CONTROL OF SIX-PHASE INDUCTION MOTOR WITH FUZZY-LOGIC SPEED CONTROLLER
Background: The paper presents the Direct Field-Oriented Control of six-phase induction motor with Fuzzy-Logic speed controller. Material and methods: Method of Space Vector Modulation has been used and the Fuzzy-Logic s...
APPLICATION OF THE SUPER-TWISTING SLIDING MODE CONTROLLERS IN DIRECT FIELD-ORIENTED CONTROL OF SIX-PHASE INDUCTION MOTOR - EXPERIMENTAL STUDIES
The paper presents the Direct Field-Oriented Control (DFOC) method of six-phase induction motor with application of the Super-Twisting Sliding Mode algorithm. The mathematical model of the six-phase induction motor has b...
UNIVERSAL SPEED AND FLUX ESTIMATOR FOR INDUCTION MOTOR
In the paper the concept of the universal speed and flux estimator with additional parameters estimators is presented. Proposed solution is based on the MRAS type flux and speed estimator and is dedicated for automotive...
DIAGNOSTIC SYSTEM FOR INDUCTION MOTOR STATOR WINDING FAULTS BASED ON AXIAL FLUX
The article presents the results of research on the use of an axial flux in the diagnostics of induction motor stator winding fed by a frequency converter. Voltage signal waveforms proportional to the axial flux were reg...
Application of Super-Twisting Sliding Mode Controllers in Direct Field-Oriented Control System of Six-Phase Induction Motor: Experimental Studies
This paper presents the direct field-oriented control (DFOC) method of six-phase induction motor with the application of super-twisting sliding mode algorithm. The mathematical model of the six-phase induction motor has...