PASIVE SUSPENSION MODELING USING MATLAB, QUARTER CAR MODEL, IMPUT SIGNAL STEP TYPE
Journal Title: TEHNOMUS - Year 2013, Vol 20, Issue 1
Abstract
The purpose of a vehicle suspension system is to improve ride comfort and road handling. In current article is simulated and analyzed the handling and ride performance of a vehicle with passive suspension system, quarter car model with two degree of freedom. Since, the equations of the system cannot be solved mathematically has developed a scheme in Matlab Simulink that allows analyzing the behavior of the suspension. The schema that was created in Matlab Simulink, were compared with the State space model and the Transfer function. After completing the simulation scheme can be introduced excitation signals, this case a step signal
Authors and Affiliations
Andronic Florin, Manolache-Rusu Ioan-Cozmin, Pătuleanu Liliana
USING VIRTUAL PARTS TO OPTIMIZE THE METROLOGY PROCESS
In the measurement process, there are many parameters affecting the measurement results: the influence of the probe system [3,5,7,15,10,16,17,19,21], material stiffness of measured workpiece [7], the calibration of the p...
ACCELERATION TEST MACHINE
Road transport of cargo is increasing year by year. The European action program on transport safety aims at an increased safety level. One important aspect of transport safety is load securing: in normal road conditions...
CONSIDERATIONS REGARDING THE FUNCTIONALITY OF THE CHUCK COLLETS
In this paper the authors aim to present the theoretical study of functionality of clenching mechanisms such as chuck collets, abbreviated MBE. For these chuck collets to function properly, a value for the angle of th...
ASPECTS REGARDING THE CONNECTIONS BETWEEN CLASSICAL ENGINEERING AND VIRTUAL ENGINEERING
Virtual reality is considered one of the fundamental directions, with computers and robotics, to reconfigure the global society in this century and even further, as one solution to overcome the current structural crisis,...
STUDY OF THERMOMECHANICAL FATIGUE FOR SHAPE MEMORY ALLOYS TYPE CuZnAl
The paper presents the design elements of a prototype installation for the study of specific thermal/mechanical fatigue of shape memory alloys, and fatigue curves obtained respectively.