Performance Analysis of Amorphous Photovoltaic Module Technology in Laâyoune -Morocco
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2018, Vol 13, Issue 6
Abstract
The main objective of this work is to study the performance of photovoltaic module based on silicon amorphous technology (a-si) installed on the roof of a building 10 m high of ESTL (Morocco). The system was monitored between December 2017 and November 2018 and all the electricity produced was injected into the building's low voltage power supply. The elements of performance evaluated monthly and annually include: energy output, system efficiency, reference yield, final yield, performance ratio and annual capacity factor. For a-Si, the investigation of the annual : Productivity EAC, System efficiency Ƞ𝑠𝑦𝑠, and performance ratio (PR) are found as 2868,33kWh, 8,67%, and 79,28% respectively. The average annual daily final yield and capacity factor were 1889,8h and 16.3% respectively.
Authors and Affiliations
H. Lotfi, A. Bennouna, D. Izbaim, M. Neffa
Keywords
Related Articles
- EP ID EP431595
- DOI 10.9790/1676-1306013542.
- Views 123
- Downloads 0
A Novel Dual Inductor DC-DC Buck Converter
A novel DC-DC Buck Converter using dual inductor and switched capacitor is proposed. Proposed circuit consists of two inductor instead of single inductor used in conventional dc-dc buck converter. The proposed converter...
Power Quality Improvement Using Interleaved Boost Converter Fed Shunt Active Filter In Photo Voltaic System
Interleaved Boost Converter(ILBC) is a better converter between Photo Voltaic(PV) source and shunt active power filter. This paper deals with comparison of time domain outputs of PI and Fuzzy Logic controlled ILBC fed sh...
Design and Implementation of Astable Multivibrator using 555 Timer
The 555 timer is widely used as IC timer circuit and it is the most commonly used general purpose linear integrated circuit. It can run in either one of the two modes: Monostable (one stable state) or Astable (no stable...
The Determination of Effects of Primary and Secondary Geometry of Tubular Linear Generator
In this paper, general information on the construction of tubular generators are given. Also, the numeric analyses were conducted by using 2D and 3D finite elements software. The output power, iron loss and cogging force...
Assessment of Atmospheric Water Generator for Rural and Remote India
With increasing human population drinking water demands are going to constantly increase which is expected to deplete water sources at ever increasing rate. United Nations SDG goals recognize this issue and identifies ac...