Performance Analysis of Economiser, Air Pre-Heater and Electrostatic Precipitator of 210MW Power Plant Boiler
Journal Title: International Journal of Engineering Research and Advanced Technology - Year 2016, Vol 2, Issue 4
Abstract
The main objective of the project is to study and understand the working and power production methods of MTPS-1. The boiler performance including its ability to meet full load, auxiliary power consumption, net plant heat rate, availability of the unit, operation and maintenance cost . An economizer is a device used to heat feed water by utilizing the heat in the exhaust flue gases before leaving through the chimney. Economizer improves the economy of the steam boiler. The following are the advantages of using an economizer. It increases the steam raising capacity of a boiler i.e., it shortens the time required to covert water into steam. It prevents formation of scale in boiler water tubes. There is about an average of 18% of coal saving. Since the feed water entering the boiler is hot, therefore strains due to unequal expansion are minimized Air heater is a heat transfer surface, in which inlet air temperature is raised by transferring heat from the fuel gas. Since the air preheater can be employed successfully to reclaim heat from the fuel gas to low temperature levels, than is possible with economizer, heat rejected to chimney can be reduced to higher extend. For every 20° C drop in flue gas exit temperature the boiler efficiency increases by about 1.0%.In addition to increase boiler efficiency. Electrostatic precipitator contains 24 fields are available in each boiler to separate almost 99% of ash and delivers in dry of wet from according to the requirement of the disposal. First age chimney height is around 130 meters and the second stage is above 220 meters. The field effective analysis is made in order to improve the efficiency of electrostatic precipitator
Free Vibration Analysis of Laminated Composite Beams using Finite Element Method
First-order shear deformation (FSDT) theory for laminated composite beams is used to study free vibration of laminated composite beams, and finite element method (FEM) is employed to obtain the numerical solution of the...
EFFECT OF PREHEATING ON THE HARDNESS of Al25Mg2Si-2Cu-4Mn ALLOY
In this paper the investigation is done on the hardness of Al25Mg2Si-2Cu-4Mn alloy. The preheated sample and as cast sample are tested on Brinell’s hardness testing machine with load of 500kg and readings were recorded a...
Effect of Weld Parameters on Mechanical Properties of Friction Stir Welded Aluminium Alloy6082-T6 and Soft Steel (Mild Steel)
Friction Stir Welding is a solid state joining process where a tool with pin, which is non-consumable, is used to join the two facing workpieces without melting them. This technique was invented in 1991 by The Welding In...
DATA VISUALIZATION
Data visualization involves presenting data in graphical or pictorial form which makes the information easy to understand. It helps to explain facts and determine courses of action. It will benefit any field of study tha...
Alert System from Disaster Management Server (DMS) By Trusted Disaster Party
Since history started human activities enforced many natural disasters. Due to continuous change in geographic position and climate, countries situated near oceans are most sensitive countries to natural disasters. The d...