Performance Analysis of OFDM and OFDM-MIMO Systems under Fading Channels
Journal Title: Engineering, Technology & Applied Science Research - Year 2018, Vol 8, Issue 4
Abstract
Fourth-generation (4G) wireless communication system is mainly based on MIMO (multiple input and multiple output) and OFDM (orthogonal frequency division multiplexing). The combination of these two techniques leads to a better system, known as OFDM-MIMO system, providing higher capacity and data rate. This paper demonstrates the BER (bit error rate) performance of OFDM and OFDM-MIMO system using convolution code to encrypt the data stream that can be sent over communication channels. Simulation is made on Matlab using three different channels (AWGN, Rician and Rayleigh). The simulation results show that the combined system has better performance compared to OFDM system. The practical part of this study was conducted by using two USRPs B210 (universal software radio peripheral) for transmitting and receiving, two antennas were used during transmission for both sides. The transmitted signal is successfully recovered.
Authors and Affiliations
A. Elsanousi, S. Oztürk
Prediction of Springback in the Air Bending Process Using a Kriging Metamodel
This paper addresses the use of the kriging approach to predict the springback in the air bending process. The materials and the geometrical parameters, which significantly affect the springback, were considered as inpu...
A Novel 2D Z-Shaped Electromagnetic Bandgap Structure
This paper researches a novel 2D Z-shaped Electromagnetic Band-Gap (EBG) structure, its dispersion diagram and application field. Based on a transmission line model, the dispersion equation is derived and theoretically i...
Electric Field Simulation Around Contaminated SIR Insulators Using MATLAB
High voltage insulators are mainly used to support transmission lines. This paper focuses on simulating the electric field along the surface of contaminated Silicone Rubber (SIR) insulators. The electric field (EF) distr...
An Anisotropic Elastic-plastic Model for the Optimization of a Press Machine’s Auxiliary Worktable Plate Thickness
In this work an anisotropic elastic–plastic finite element model strongly coupled with ductile damage is applied to determine the suitable thickness of added auxiliary worktable plate to a 100 ton maximum capacity press...
Heat Transfer and Fluid Flow in Naturally Ventilated Greenhouses
In this paper, heat transfer and fluid flow in naturally ventilated greenhouses are studied numerically for tow configuration according to the number and positions of the opening. The equations governing the phenomenon a...