Physical properties of Nano based Bio-Oils as cutting fluids
Journal Title: Journal of Advanced Research in Manufacturing, Material Science & Metallurgical Engineering - Year 2018, Vol 5, Issue 3
Abstract
The performance of any cutting fluid depends on its physical properties. A good cutting fluid should have high flash and fire point, so that it can withstand high temperature; resulted due to friction between tool-chip interface & tool -workpiece interface. Viscosity should not be high as cutting fluid will not carry away the heat and chip produced. It should not be low also as, the oil just flows from machining zone without doing its intended function, hence Viscosity should be optimum. Cutting fluid should have high specific heat so that heat absorption will be high and optimum Adhesivenessfor good lubrication. The present paper discusses the physical properties of various bio-oils,SAE 20W40 (petroleum based oil), and compares the results measured with the addition of nano Graphite powder
Authors and Affiliations
Susmitha Medarametla,
Keywords
Related Articles
- EP ID EP535301
- DOI -
- Views 133
- Downloads 0
Application of Lean Manufacturing in Automotive Industry: A Review
This review paper is regarding the topic of Lean Manufacturing. “Lean Manufacturing” is a production practice that aims to cut down inventory on the shop floor of a manufacturing firm. Its origins extend deep into the hi...
Microstructure and Characterization of Ni-Cr Alloy-Spray Repaired Steel
In today’s era of manufacturing, wear upon the surface of component is the major problem of all materials. This wear can be reduced to great extent by applying some coating onto the surface of material. The as-sprayed co...
Experimental Assessment of a Laboratory Rotary Sample Splitter
A binary mixture of iron chips and sand was used to experimentally test the performance of a constructed laboratory sample splitter. Four tests were conducted and six subsamples were produced in each case. The subsamples...
Multi Objective Optimization of Pitting Corrosion Rate of Micro Plasma Arc Welded Titanium (Ti-6Al-4V) Alloy Sheets using TOPSIS
Titanium is having good anti-corrosion properties in both basic and acidic medium. However, when it is subjected to severe heating processing like welding, there is a possibility of corrosion formation at the weld joint....
Line Balancing Technique Improves Productivity At Chipset Tester Assembly Manufacturing: A Review
This paper reviews line balancing technique that used to for productivity purpose. Globalization is one of the key factors that brought growth in the chipset production demand. As a tester supplier for the chipset world,...