Possibility of Producing Sintered Fine Porous Granulated Ceramic Filler Using Ash of Thermal Power Stations in Combination with Clay Rocks
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 4
Abstract
In localities where rocks for production of coarse and fine fillers are unavailable, it becomes necessary to develop innovative artificial materials based on processing of local nonconventional natural and manmade feed stocks. This work presents experimental studies devoted to development of sintered fine porous granulated ceramic filler based on ash of thermal power station in combination with clay rocks. Clay–ash ceramic composition has been studied. Ash content in this composition was from 10 to 30%. Granules of the ceramic composition were sintered in rotary kiln at 1,000°C. Main features of physico-mechanical properties of samples were studied as a function of ash content up to 30%. With addition of ash of Ekibastuz Power Station in amount from 10%to 30%, the strength of granules increases. Thus, at annealing temperature of 1,000°C, the strength increases to 12.4 MPa. Here with, the average density decreases and is from 1,250 kg/m3to 910 kg/m3. The obtained experimental data also evidence intensification of sintering and crystallization in ceramic pastes containing ash of Ekibastuz Power Station. Samples without ash addition are characterized by dense sintered structure with insignificant micropores. Granules with ash addition to 30%are characterized by developed sintered porous structure. It has been established that keramdor materials based on the considered composition are characterized by strong microporous structure after annealing. In addition, ash of Ekibastuz Power Station in the ceramic paste exerts favorable influence on heat conducting properties of sintered microporous granulated ceramic filler, which makes it possible to use them as material, increasing energy efficiency of buildings and structures. The use of ash in ceramic paste for production of granulated sintered microporous material allows improving environmental protection, partially.
Authors and Affiliations
Sarsenbek Aliakbaruly Montayev, Nurgul Sarsenbekovna Montayeva, Altynay Bakytzhanovna Shinguzhiyeva, Karzhaubai Zhanabaevichdosov, Muratbai Zhanaidarovichryskaliyev
Keywords
Related Articles
- EP ID EP656877
- DOI 10.24247/ ijmperdaug2019112
- Views 80
- Downloads 0
Design and Analysis of Steam Turbine Blade
Steam turbine changes over the warmth vitality of steam into helpful work. Steam planes strike the moving columns of sharp edges mounted on rotor causes alter the course of steam which grants energy. In this manner, tape...
Fabrication and Evaluation of Mechanical Properties of Bermuda Grass Root Fiber/Polyester Composites
Bermuda grass root fibers were comprehensively characterized to access their potential as reinforcement materials in polymer composites. An experimental study has been conducted to investigate the mechanical properties o...
Optimization of Wire EDM Process Parameters for Machining of AMCs (413/B4c) using Taguchi Technique
The effects of the machining parameters in Wire Electrical Discharge Machining (WEDM), by varying pulse on time, pulse off time, gap voltage and wire feed on the machining characteristics of fabricated Aluminium Matrix C...
Influence of Tool Pin Geometry on Friction Stir Welded 597 Dissimilar Aluminium Alloys - (AA5083 & AA6061
The present examination focuses on the evaluation of process parameters on mechanical properties and microstructure study of Friction stir welded (FSW) unlike Aluminum alloys. Their extent of use is in naval and marine a...
Flexible Manufacturing Systems (FMS): A Review
Today’s manufacturing environment demands for manufacturing performance to accomplish the task in the stipulated time interval. Hence, flexibility of the manufacturing systems becomes an important issue which has led to...