Recent Advances and Future Perspectives for Reinforcement of Poly(methyl methacrylate) Denture Base Materials: A Literature Review
Journal Title: Journal of Dental Biomaterials - Year 2018, Vol 5, Issue 1
Abstract
Poly(methyl methacrylate) (PMMA) is the most common material used to fabricate complete and partial dentures. Despite its desirable properties, it cannot fulfill all mechanical requirements of prosthesis. Flexural fatigue due to repeated masticatory and high-impact forces caused by dropping are the main causes of denture fractures. In the past, different reinforcing agents such as rubbers, macro fibers, and fillers have been employed to improve the mechanical properties of denture base resins. Development of Nano dentistry has introduced new approaches for reinforcement of dental materials. Interest in nanostructure materials is driven by their high surface area to volume ratio, which enhances interfacial interaction and specific new biological, physical, and chemical properties. Researchers to reinforce PMMA resins have used Nanoparticles (Nps) which were comprised of silver, Titania (TiO2), zirconia (ZrO2), alumina, and ceramic. Although different reports describe the use of nanofiber and nanotubes in dental composites, few studies have evaluated the reinforcement potential of nanofiber and nanotubes in PMMA denture base resins. The current article aims to review the different attempts to enhance the mechanical properties of denture base materials. We also focus on recent advances and potential future developments for reinforcement of the PMMA acrylic resins.
Authors and Affiliations
Sahar Abdulrazzaq Naji, Tahereh Sadat Jafarzadeh Kashi, Marjan Behroozibakhsh, Hamidreza Hajizamani, Sareh Habibzadeh
Keywords
Related Articles
- EP ID EP267227
- DOI -
- Views 55
- Downloads 0
Cytokeratin: a Shortcut to Diagnose Spindle Cell Carcinoma
A relatively rare subtype of squamous cell carcinoma (SCC) is spindle cell carcinoma (SPCC). It is composed of epithelium-derived spindle cells arranged in sheets with mesenchymal properties and small, hard-ly detectable...
Comparing the Accuracy of Silicone and Polyether in Reproducing Gingival Height for Implant Supported Crown: an in vitro study
Statement of Problem: Accurate impressions are one of the most critical factors in achieving acceptable restorations. When pouring the impressions of implant supported restorations, soft materials like silicone and polye...
A Comparison of Push-Out Bond Strength of Two Endodontic Sealers to Root Canal Dentin: An in Vitro Study
Statement of Problem: Adhesion to root canal dentin is one of the necessary characteristics of endodontic sealers. MTA Fillapex (Angelus, Londria, PR, Brazil) is one of the recently introduced MTA-based sealer. Only a li...
Fracture Toughness of Resin Composites under Different Modes and Media: Review of Articles
This article aims to review various modes of fracture toughness of resin composites. Also, this study intends to review the papers on the fracture mode, namely “fractography”, under scanning electron microscopy finding f...
Evaluation of Compressive Strength and Sorption/Solubility of Four Luting Cements
Statement of Problem: Compressive strength (CS) and sorption/solubility of the luting cements are two associated factors. Searching a correlation between sorption/solubility and compressive strength of various luting cem...