Research and control of the purity of production hydrogen with a high degree of purification when applying the electrolysis method of production
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 1, Issue 6
Abstract
<p>We conducted experimental studies aimed at determining the purity of hydrogen obtained at the electrolysis installation made by Hydrogen Technologies (Norway) at the pipe plant Centravis Production Ukraine in the city of Nikopol, Ukraine.</p><p>It was established that the determination of hydrogen purity and the degree of its purification from impurities (nitrogen) in microconcentrations involves two stages of measurements:</p><p>− research into the presence of nitrogen in the samples of production hydrogen in the microconcentrations of [[N2] 0.001−0.01 % (rough estimate);</p><p>− research into the presence of nitrogen in the samples of production hydrogen in the microconcentrations of [[N2] 0.001−0.01 % (fine assessment).</p><p>We determined that the purity of production hydrogen, obtained during research, was 99.9±0.1 %. A given value for purity does not match certification indicators for purity of production hydrogen claimed by the manufacturer to equal 99.9999 %.</p><p>We analyzed the reasons for the mismatch between the purity of obtained hydrogen and claimed characteristics. A detailed analysis revealed that the possible cause of high nitrogen concentration in hydrogen is the worn piston rings in the stage of compressor pistons, which causes the penetration of nitrogen in microconcentrations into production hydrogen. Piston rings in the compressor's stage were replaced. Repeated studies into purity of production hydrogen indicate that the purity of production hydrogen amounted to 99.99±0.01 %, which corresponds to the hydrogen of grade A.</p>
Authors and Affiliations
Valeriy Nikolsky, Olga Oliynyk, Viktor Ved, Olena Gnatko, Andrii Pugach, Iuliia Bartashevska
Keywords
Related Articles
- EP ID EP527772
- DOI 10.15587/1729-4061.2018.124085
- Views 72
- Downloads 0
Analysis of properties of epoxy compositions that operate in contact with water and oil products
<p>We modified epoxy resin-based polymer solutions to increase durability in aggressive environments and to reduce costs. We achieved the objective via filling them with the multifractional mineral frame and modification...
Development of the method for the formation of one-dimensional contours by the assigned interpolation accuracy
<p>The purpose of the study is to develop a method for the formation of a one-dimensional contour with provision of a given accuracy of interpolation. Determination of the accuracy of interpolation relies on the formatio...
Establishing rational structural-technological parameters of the milking machine collector
<p>A collector of the milking machine is the nodal element in the system of accumulation and transportation of the received milk to a milk pipeline. It was established that the structural-technological parameters of the...
An impact of the ladle lining on the refining of reinforced steel when blowing with powders
<p>When refining steel by blowing powders, the ladle lining material plays a serious role. The dependency graphs of the degree of desulfurization on the consumption of silicocalcium powder during blowing in ladles lined...
Development of information technology of term extraction from documents in natural language
<p class="KeywordsCxSpFirst">It is shown that domain dictionaries are widely used at various stages of design and operation of software products. The process of dictionary development, especially term extraction, is very...