Research of Non-metallic Inclusions Removal in Teeming Ladles of Various Design
Journal Title: Журнал інженерних наук - Year 2018, Vol 5, Issue 2
Abstract
It was studied in the article the possibility of intensification of removal of non-metallic inclusions in a teeming ladle during holding without any additional external influences on the metal (argon blowing or electromagnetic stirring). Increasing the efficiency of removal of non-metallic inclusions is achieved by creating in a teeming ladle during tapping a circulation pattern that accelerate the floating of inclusions. The described effect is achieved by using a rational shape of the workspace of the teeming ladle, which has been found as a result of “water” modelling. To carry out the experiment, the authors have proposed the similarity numbers describing the floating of non-metallic inclusions in the ladle during the tapping and for some time after its completion. On the basis of the proposed similarity numbers, an experimental facility and the experimental method were developed. In the course of the experiment, the construction of linings of several types was studied. Ladles of the best design provide by 16–19 % faster removal of non-metallic inclusions from steel than in ladles of conventional design. The results of the research can be useful for mini-plants and enterprises with ladles of small capacity, where the use of argon blowing and electromagnetic stirring is technologically and economically unreasonable.
Authors and Affiliations
L. S. Molchanov, Y. V. Synehin, O. S. Lantukh, I. S. Ryshkova
Keywords
Related Articles
- EP ID EP416400
- DOI 10.21272/jes.2018.5(2).c1
- Views 74
- Downloads 0
Intensification of Foam Layered Apparatus by Foam Stabilization
In this work the expanded models are studied for foaming apparatuses with gratings made of tubes for different diameters. The problem of intensification of foam devices using coarse-grating lattices is considered. The po...
Mathematical simulation of fluid flow and analysis of flow pattern in the flow path of low-head Kaplan turbine
The results of numerical investigation of spatial flow of viscous incompressible fluid in flow part of Kaplan turbine PL20 Kremenchug HPP at optimum setting angle of runner blade φb = 15° and at maximum setting angle φb...
Application of Rough TOPSIS Technique for the Analysis of Engineering System Failure Causes
The prioritization of the causes of engineering system failure posed to be a challenge. Therefore, there is a need to develop a tool that will be used to identify critical problems of an engineering system to facilitate...
Research of Mechanical Properties of Thermite Material on the Basis of Steel Dross
Important direction in the development of technologies for the recycling of wastes of industrial productions is inclination on the use energy saving technologies. The article deals with general aspects of methods of util...
Diamond Grinding the Ceramic Balls from Silicon Carbide
The influence of the machining regime was experimentally investigated on the output indexes of the diamond grinding the ceramic balls from silicon carbide, such as the rate of the material removal and the rate of changin...