Research on Geometric and Kinematic Analyses of Some Auxiliary Mechanisms Used on Urban Buses
Journal Title: Scientific Bulletin, Automotive Series - Year 2017, Vol 27, Issue 1
Abstract
The paper presents the geometric-kinematic modeling of an articulated planar mechanism used to actuate the urban bus doors. The stages of solving the kinematic parameters as displacement, velocity and acceleration of each component of the linkage are performed. One of the goals of the paper is to use this modeling of kinematics to improve the operation of the mechanism as synchronization of the two folding doors. The velocity and acceleration of them are also important due to the fact that it can create a safe environment for the passengers. Before this study, a similar type of linkage used on trolleybuses is presented in brief. Also, a review of the main types of urban bus doors is emphasized in section 2.
Authors and Affiliations
Daniela ANTONESCU, Daniel IOZSA, Ovidiu ANTONESCU, Gheorghe FRATILA
Keywords
Related Articles
- EP ID EP288805
- DOI 10.26825/bup.ar.2017.003
- Views 28
- Downloads 0
The influence of the Technological Deviations over the Vibration Inherent Frequencies at Bending from the Three-Shafts Transmission
The technological deviations of manufacturing and assembly , lead to the change of the kinematic parameters and at further efforts in the kinematic pairs of the cardan joint mechanism from the component of the poly-carda...
Kinematic and dynamic analysis of planetary mechanisms with two degrees of freedom used for power sources coupling
In this paper we perform a review of the planetary gear trains with two central gears, and a planet carrier, used for power sources coupling. The kinematic and dynamic analysis was determined for a simple planetary gear...
Theoretical and experimental considerations regarding to functioning of a combat vehicle shutter’s hydraulic actuation system
The paper proposes a theoretical analysis of kinematic and dynamic performances of several elements in the composition of a combat vehicle shutter’s hydraulic system, using LMS AMESim, specialized CAE software.
Carbon Dioxide Control Technologies for Diesel Engines
The main pollutants contributed by internal combustion engines are CO, NOx unburned hydro-carbons (HC) and particulate emissions. In addition to this, all fuel burning systems emit CO2 in large quantities and this is con...
A study upon medium displacement Diesel Engine failure
The study aims to determine the failure cause of an internal combustion engine, in a particular case for a medium displacement diesel engine. The general issue of internal combustion engines failure is very complex and c...