RESEARCHING OF THE CONFORMANCE RATING FOR LOCOMOTIVE REPAIR PRODUCTION
Journal Title: Збірник наукових праць Українського державного університету залізничного транспорту - Year 2017, Vol 173, Issue 7
Abstract
The determination of the conformance rating of locomotive repair production is associated with the formalization of expert statements obtained during its survey. In the article the structure of the compliance indicator of locomotive repair production is analyzed, which is defined as the triple additive convolution of a number of criteria. Herewith it is taken into account: the rate of influence of nonconformities on the technological process of repair, the significance of technological repair processes, the significance of components of repair production and the significance of failures of locomotive units. Analysis of data of survey of locomotive repair productions shows that the total number of identified nonconformities lies in the range of 20-30. Herewith the most negative influence will have nonconformities, which are characterized by the maximum values of the criteria. In the article the critical values of the criteria for the conformance rating are defined, that is, those that can be a prerequisite for severe consequences if the repaired locomotive fails in exploitation. It is determined that the critical range of the weight of only nonconformity of production lies in the range of 0.012-0.063. And the acceptable values of the conformance rating of locomotive repair productions are 0.988 - 1.
Authors and Affiliations
Yurii Datsun, Y. Bezhenar
Keywords
Related Articles
- EP ID EP324456
- DOI -
- Views 59
- Downloads 0
METHOD FOR CALCULATING REINFABRICATED REINFORCED CONCRETE LINING OF A PRESSURE HYDRAULIC TUNNEL
The analysis of structural features and operating conditions of the prefabricated reinforced concrete lining of a pressure hydraulic tunnel was carried out. The requirements to be met by the elements of the lining in que...
ANALYSE OF STRENGTH GLUED-IN STEEL RODS INSTALLED IN LVL BY TAKING INTO ACCOUNT STRENGTH BY SHERE
The glued-in steel rods as an effective method for performing rigid joints of timber structures are used in joints of elements from new wood based materials, including veneer based. The LVL elements has high strength cha...
MODERN DIRECTIONS OF AUTOMATION OFTRAIN DISPATCHING ON THE RAILWAYS OF THE WORLD AND PERSPECTIVES OF THEIR IMPLEMENTATION IN UKRAINE
In this work the existing directions of automation of train traffic dispatching on the railways of the world and possibilities of their introduction on the railway transport of Ukraine are investigated. Following the exa...
CALCULATION OF COMPRESSED AND BENDED STEEL REINFORCED CONCRETE CONSTRUCTIONS IN THE RETAINED FORMWORK
The problems of calculation of compressed and bended steel reinforced concrete structures in the retained formwork were considered. Apart it’s necessary to consider the questions which are related with calculation tube...
DESIGN OF POLYGONAL COVERAGE COATINGS OF WOOD
Currently in Ukraine the production of wooden I-beams with a wall of OSB is a steady increase. Analysis of the structural forms of composite beams, the features of their use in the frame of buildings, along with the exis...