Roller Forming Unit Dynamic Analysis with Energy Balanced Drive Dissipative Properties Taken into Account
Journal Title: Проблеми машинобудування - Year 2018, Vol 21, Issue 2
Abstract
In order to increase the reliability and durability of a roller forming unit with an energy-balanced drive, loads in the unit structure elements and drive are calculated, dependencies for identifying efforts in the connecting rods, necessary for setting the forming trolleys in reciprocating movement, and normal reactions of the forming trolley guide rails to the guide rollers depending on the rotation angle of the cranks are obtained. For researching into loads, a two-mass dynamic model of a roller forming unit is used, in which the load and inertia characteristics of the drive motor and each of the forming trolleys as well as rigidity of the drive and its dissipation are considered. Function of change of the required moment for ensuring the process of compacting products from building mixtures, taking into account drive dissipation, is defined. By the average value of the resistance moment for one crank rotation cycle, the rated power is chosen, on which the electric motor, clutches and reducer are chosen. Using Lagrange’s equation of the second kind differential equations of movement are worked out for a roller forming unit with an energy-balanced drive presented by a two-mass dynamic model. As a result of the numerical experiment for a roller forming unit with an energy-balanced drive, the value of the drive rigidity (reduced to the crank rotation axis) at which the minimum loads in the drive clutches are observed, is determined. Dependence of the drive clutch torque from the dissipation coefficient value is determined. The recommended dissipation coefficient value for a roller forming unit with an energy-balanced drive is determined.
Authors and Affiliations
V. S. Loveikin, K. I. Pochka, Yu. O. Romasevych
Keywords
Related Articles
- EP ID EP622074
- DOI 10.15407/pmach2018.02.032
- Views 46
- Downloads 0
Numerical analysis of stress-strain state of vertical cylindrical oil tanks with dents
The destruction of vertical cylindrical tanks results in both human and economic losses. Despite constant improvement of the manufacturing technology of cylindrical tanks, a complete analysis of the influence of various...
Modernization of an experimental installation and a procedure for investigating the anisotropic viscoelastic properties of composite materials at elevated temperatures
The paper describes the process of modernizing the existing installation designed for performing long-term tests of steel and aluminum cylindrical specimens for high-temperature creep with the purpose of conducting the e...
Peculiarities of Identifying a Power-generating Single-shaft GTE Mathematical Model
The processes of designing and developing gas turbine engines (GTE) are based on using mathematical models (MM), reflecting the physical picture of engine operation processes. One of the ways of improving the MM validity...
Dynamic Processes During the Through-plastic-damper Shock Interaction of Rocket Fairing Separation System Components
This article deals with the actual issues of ensuring the dynamic strength of rocketry components using pyrotechnics. It studies the shock interaction of rocket fairing pyrotechnic separation system components during the...
Method for the Optimal Design of Vacuum-Evaporative Heat Pumps
A method is developed for optimally designing vacuum-evaporative heat pumps that use water (R718) as a refrigerant. This method is based on the autonomous method of the thermoeconomic optimization of thermodynamic system...