Розрахунок за деформаційною моделлю залізобетонних колон, підсилених вуглецевою стрічкою

Abstract

In this paper for calculation of reinforced concrete columns strengthened with carbon laminate with suggestions based on the method of calculation according to the recommendations NIISK and Sika on the basis of deformation model calculation according to regulations . To determine the additional eccentricity introduced by bending flexibility factor, which is derived using in Eurocode 2. The algorithm for calculating strengthened at the primary level loading columns. In the developed method of calculation based on proposed a methodology to take account of the inclusion of work carbon laminate reinforcement. For Strengthening effect by main reinforcement’s yield state different of theoretical results with experimental is 5.65–7.5 % towards lowering the theoretical values. The discrepancy between the theoretical bearing capacity of columns with experimental for limit compressive strain of concrete is 8.35–9 % towards underestimation of experimental theoretical values. Calculation of load capacity noncentral compressed columns by method gives satisfactory results with theoretical values of strength is less than the expiremental, allowing you to recommend the proposed method of calculation to use.

Authors and Affiliations

Ya. Blikharskyy, R. Khmil, P. Kholod

Keywords

Related Articles

COMPARING OF THE VOLUME OF STORMWATER RUNOFF FROM TYPICAL RESIDENTIAL CATCHMENTS IN LARGEST CITIES, CALCULATED ACCORDING TO UKRAINIAN NORMATIVE DOCUMENTS

It was analyzed Ukrainian normative documents, regulating the procedure of calculating the average annual volume of stormwater runoff from urbanized areas. It was found the big differences as in the numerical values of t...

Дослідження температурних режимів пожеж у житлових приміщеннях на моделях зменшеного масштабу

This paper is the results of the experiment to study the dynamics of fire in the premises of residential buildings on models size reduction and improvement of methods for determining the temperature conditions of movemen...

CHARRING DEPTH OF FIRE PROTECTED STUDS IN TIMBER FRAME WALL ASSEMBLIES EXPOSED TO FIRE

The present standards do not consider cases for timber elements covered with fire- resistant penetrating coatings and jointed claddings simultaneously. This article is focused on the influence of such combined fire prot...

Оптимальне розташування вирівнювальної пластини в конструкції дифузора для підвищення тискових та витратних характеристик вентиляційних систем

At work investigates the incoming flow and its alignment to the ventilation system elements, located directly outside a radial fan. The efficiency of the ventilation system depends on the improvement of its aerodynamic c...

Покращення експлуатаційних властивостей керамічної цегли поверхневим модифікуванням поверхні

In the article there are substantiated and determine the optimal composition of protective covering by the mathematical planning method with taking into account the influence of protective covering on water absorption, a...

Download PDF file
  • EP ID EP230162
  • DOI -
  • Views 87
  • Downloads 0

How To Cite

Ya. Blikharskyy, R. Khmil, P. Kholod (2016). Розрахунок за деформаційною моделлю залізобетонних колон, підсилених вуглецевою стрічкою. Вісник Національного університету "Львівська політехніка". Серія "Теорія та практика будівництва", 0(844), 3-12. https://europub.co.uk/articles/-A-230162