Safety Belt Operated Pneumatic Handbrake
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2017, Vol 5, Issue 5
Abstract
In this Paper we studied that in a ground vehicle, mechanical parking brake (Hand brake) unit is a mechanism that used to hold the vehicle motionless either on the even or gradient road. It consists of a directly linked to the brake mechanism on one end and to a mechanism that can be motivated by the driver on the other end. This actuating mechanism is often a handoperated lever on the base on either side of the driver, or a pull handle located below and close the steering wheel column or a (foot-operated) located far separately from the other pedals. In order to confirm that a vehicle remains stationary when it is parked at a certain road slope, the driver has to apply adequate dragging force on the handbrake lever. Seat belt is applied in car to ensure drivers safety. The rise in number of loss of life in accidents is due to driver’s carelessness to wear seat belt though it is strictly forced by law. The aim of our project is to make seat belt wearing compulsory for vehicle momentum. This could be achieved by using pneumatic setup along with handbrake. The change to be done ensures that the driver wears seat belt in driving. Here the seat belt of the car initiates the hand brake (parking brake) through a pneumatic cylinder. The main benefit of this system is that traveller/driver safety, if we don’t use seatbelt the vehicle handbrake dose not removes for safety. This system will be employed in car to ensure travellers/driver safety. It reduces in number of loss of life in accidents. We can attain it by using pneumatic setup along with handbrake.
Authors and Affiliations
Ugale V. J. , Gade S. D. , Pagar S. S, Shirsath S. D. , Prof. Aher S. S.
Analysis and Implementation of PMBLDC Motor Drive with CUK Converter
This method is used to improve the efficiency of motor drive by power factor correction. It plays an important role in energy saving during energy conversion. A cuk dc -dc converter topology reduced the power quality pr...
slugUltra-wideband L-strip proximity coupled slot loaded semicircular microstrip antenna
An analysis and design of a nove l ultra wideband L - strip proximity coupled sl ot loaded semicircular micro strip antenna is proposed. The structure is simulated on MoM based IE3D si...
Opportunistic and Probabilistic Dynamic Spectrum Access in Cognitive Radio Networks
Opportunistic spectrum access has become a high priority research area in the past few years. The motivation behind this actively researched area is the fact that the limited spectrum available is currently being utiliz...
Modelling and Simulation of Dc to Ac Converter for Renewable Energy Source Using Simulink
This paper deals with modeling and simulation of DC-AC converter for Renewable Energy Source. DC from the solar cell is stepped up using a Boost converter. The output of the Boost converter is converted in to three-phas...
Numerical Modeling and Analysis of Hydro Turbine Draft Tube with Different Geometry Using Fluent
the efficiency of a hydraulic reaction turbine is significantly affected by the performance of its draft tube. The shape and velocity distribution at the inlet are, in next turn, two main factors that affects the perfor...