Saturator Efficiency and Uncertainty of NIS Primary Standard for Relative Humidity Calibration
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 4
Abstract
In the last ten years, there has been associate interest of makers and laboratories in having more accurate humidity measurements. Electrical relative humidity (RH) sensors have been widely used. These sensors need to be calibrated, and therefore the uncertainty measurement of these sensors has become a major concern. This paper describes the relative humidity uncertainty analysis and uncertainty contribution from saturator efficiency for the National Institute of Standards’ (NIS-Egypt) two-pressure humidity generator. Efficiency tests were administrated. The saturator efficiency test results showed smart performance of the generator, as described below. Uncertainty analysis was also represented for all the sources that touch measurements. The expanded uncertainty of a coverage factor k=2 was found to be from ± 0.1% to ± 0.45% for relative humidity.
Authors and Affiliations
Doaa Mohamed Abd El-Galil, Essam Mahmoud, Ahmed El-Matarawy
Keywords
Related Articles
- EP ID EP655820
- DOI 10.24247/ijmperdaug201959
- Views 76
- Downloads 0
Dynamic Stability of Plates Resting on Elastic Foundation
An accurate closed form solution to predict the dynamic stability behaviour of a square plate resting on an elastic foundation subjected to edge periodic loads, has been obtained. The Energy method is applied to solve th...
Computational Investigation on Thermo hydraulic Characterization of Liquid Hydrogen and Liquid Nitrogen in Micro channels
Due to increasing application of Micro-Electro-Mechanical Systems (MEMS), are in constant need of better and improved understanding of fluid flow and heat transfer characteristics, in micro channels. This paper offers a...
CFD Simulation of Flow Past Wing Body Junction: A 3-D Approach
Turbulence and flow disturbances occurring at the wing body junction of aircraft causes aerodynamic drag and decreases the performance. The main objective of this work is to modify the design at wing body junction by the...
Characterization of Structural Properties and Harden Enhancement of Al-Cu-N by Thin Film Coating
Two series of Al-Cu-N films containing Cu were grown by DC / RF magnetron sputtering of two elemental targets in an Ar / N & sub2; Gas mixture deposited by biasing a high-speed steel substrate. The effects of Cu content...
DESIGN AND PERFORMANCE EVALUATION OF POLYHEDRAL SWEPT BACK HIGH WING CHUCK GLIDER FOR BETTER L/D RATIO
“It’s not flying its falling in style.” The chuck gliders are the ones which do not require any kind of thrust force since these do not have any mechanical or electrical power supply to it. For flying of such gliders, th...