Selecting cutting modes for high-speed titanium-tungsten instruments at cutting pneumatic tires
Journal Title: Вісник Тернопільського національного технічного університету - Year 2016, Vol 83, Issue 3
Abstract
Results of experimental researches of technical processes of used pneumatic automobile tires utilization are given to determine the most effective cutting tool’s material and cutting mode during their cutting in half.
Authors and Affiliations
Oleksandr Sasov, Serhij Sychov,
Mathematical modeling of led radiation in the system of medical diagnostics
The use in the medical diagnosis light irritation with intensity lower than standard level leads to decreasing invasiveness and increasing resolution of bioobject response. This improves the quality of diagnosis the stat...
Mathematical model of boundary crack propagation at bending of symmetric thin-walled flanks
There was studied engineering methods for determining stress intensity factors for complex symmetrical cross-sectional flank open at the edge of the crack by the action of stretching and bending effort. Analysis of speci...
Thermomechanical behavior of thick-walled viscoelastic cylindrical panel
The statement of three-dimensional problem on the forced resonance vibrations and dissipative heating of the viscoelastic thick-walled cylinder panel with simply supported edges is presented. The nonelastic material beha...
Theoretical analysis of thermal conditions and ways of led temperature stabilization
Thermoelectric model of a light diode was built with a spacial separation of the heat and cold source. The differential equations system was solved, which comprises the stationary equation of the heat-conductivity and th...
Robust stability and evaluation of the quality functional of linear discrete systems with matrix uncertainty
New methods for analysis of robust stability and optimization of discrete output feedback control systems are developed. Sufficient stability conditions of the zero state are formulated with the joint quadratic Lyapunov...