Simulation Segregaton in CMSX-4 Superalloy: Experiments and Simulation Predictions
Journal Title: Jurnalul Stiintific TURBO - Year 2017, Vol 4, Issue 1
Abstract
The segregation degree of alloying elements during solidification in as-cast CMSX-4 singlecrystal superalloy was investigated. The elemental partition coefficients calculated using the results of experimental measurements of local compositions and predicted by thermodynamic calculation in multicomponent alloys have shown the tendency of the elements to segregate either into the dendrites (W, Re) or in the interdendritic regions (Al, Ti, and Ta). Among the alloying elements Re has the strongest tendency to segregate. It was found a good agreement between the experimental and simulation prediction results, as well as compared with an analytical model. By thermodynamic calculation it was established the influence of superalloy chemistry on the elemental segregation during solidification.
Authors and Affiliations
Gheorghe MATACHE, Alexandru PARASCHIV, Cristian PUSCASU, Mihaela Raluca CONDRUZ
Keywords
Related Articles
- EP ID EP268864
- DOI -
- Views 146
- Downloads 0
POWER CORRELATION OF DRIVING MOTOR FOR TURBO BLOWER WITH INDUSTRIAL PROCESS REQUIREMENTS
The turbo blowers are high-speed pneumatic bladed machines, great consumers of mechanical work. They are classified within the group of dynamic compressors, used for raising the pressure of gas. The turbo blower can be d...
Numerical simulations of pulse combustion in Schubert pulsejet engines
Currently, there is no mathematical model or procedure for designing a pulsejet engine that provides sufficient accuracy to be used in practice. For this reason, the paper addresses the problem by achieving a CFD study o...
EVALUATION OF FATIGUE BEHAVIOR ON CARBON FIBER/EPOXY COMPOSITE LAMINATES AT ROOM TEMPERATURE
Investigation of low-cycle fatigue of composites is of vital importance for the design of structural components. In this study, Low cycle fatigue behaviour of a CFR epoxy composite was investigated under sinusoidal wave...
Calculation of the Delamination Yield Index
This paper presents a numerical simulation model of the delamination process of a laminated made up of polimerical composite materials ranforced with carbon fibres. Moreover, a set of experimental tests have been done to...
Optimising Low Speed Dynamic Balancing of High Speed Rotors
The research conducted revealed some particularities of the rotors manufactured and/or assembled at INCD Turbomotoare COMOTI. Different phenomena were encountered, named, and described, using data recorded while dynamica...