STATISTICAL PROCEDURES FOR TWO-SIDED LIMIT OF A CONTROLLED PARAMETER IN THE PROCESS OF PRODUCTION OF CABLE AND WIRE PRODUCTS
Journal Title: Електротехніка і Електромеханіка - Year 2016, Vol 0, Issue 5
Abstract
Purpose. To consider issues of statistical control in the process of mass production of cable and wire products on the example of enameled wire. To analyze the results of direct control of the diameter of the wire in two-layer polyimide insulation in a continuous technological cycle. To submit to the control map of maximum probability of the exit diameter outside a specific range. To analyze the conditions under which maximum sensitivity of process control. Methodology. Study of the sensitivity of the control map of maximum probability of the exit option for regulatory of limit in the field deviations of the centered parameter close to zero. The existence of stable trends in the change of a controlled parameter can reduce the sensitivity of punishment to instability of the process. Results. To achieve maximum sensitivity of control of the technological frontier should be selected on the basis of the achieved level of the average value of the parameter and its statistical scattering. Process boundaries must be changed in accordance with the achieved level of the average value of the parameter and its statistical scattering. Such a change may serve as a quantitative indicator of trends in the increase or decrease in the reliability of the technological system. Originality. In particular the tasks of current control using engineering tolerances for controlled parameter are impractical. Control on Pmax should be directed to the exception of manufacturing, the parameters of which extend beyond the technical tolerances. Practical value. The exception is the manufacture of bulk cable products, the parameters of which extend beyond the technical tolerances.
Authors and Affiliations
O. V. Golik
Keywords
Related Articles
- EP ID EP297726
- DOI 10.20998/2074-272X.2016.5.07
- Views 77
- Downloads 0
THE PROBLEM OF CORRECT CHOICE OF FERRITE BEADS
A ferrite bead is a passive electrical element used to suppress high-frequency noise in electric circuits. This is one of the simplest and the cheapest type of filters. Thus, such filters are widely used in electric and...
PROFESSOR P.P. KOPNIAIEV – SCIENTIST, PUBLIC PERSON, ESTABLISHER OF HIGHER ELECTRICAL ENGINEERING EDUCATION (to the 150th anniversary of his birth)
Purpose. To carry out complete historical and scientific analysis of Professor P.P. Kopniaiev's activities and establish his role and place of achievements in the formation of the basic concepts and directions of the the...
INVESTIGATION OF CHANGES OF PHYSICAL AND CHEMICAL PROPERTIES OF TAP WATER UNDER INFLUENCE OF POWERFUL UNDERWATER SPARK DISCHARGES
Purpose. The purpose of this investigation is to study the changes in the redox potential and pH-value of the tap water as a function of underwater spark discharges, storage device capacitance and the charging voltage. M...
A MATHEMATICAL MODEL OF THERMAL POWER PLANTS SMOKE EXHAUSTERS INDUCTION MOTORS SYSTEM OPERATION MODES
Purpose. Development of a model-software complex (MSC) for computer analysis of modes of the system of induction motors (IM) of smoke exhausters of thermal power plant (TPP), the basic elements of which are mathematical...
NUMERICAL ANALYSIS OF MATHEMATICAL MODELS OF THE FACTUAL CONTRIBUTION DISTRIBUTION IN ASYMMETRY AND DEVIATION OF VOLTAGE AT THE COMMON COUPLING POINTS OF ENERGY SUPPLY SYSTEMS
Purpose. Perform numerical analysis of the distribution of the factual contributions of line sources of distortion in the voltage distortion at the point of common coupling, based on the principles of superposition and e...