STEEL LATTICE TOWER UNDER ULTIMATE LOAD – CHOSEN JOINT ANALYSIS
Journal Title: Civil and Environmental Engineering Reports - Year 2017, Vol 2, Issue 25
Abstract
The main objective of the presented paper is to discuss chosen lattice tower joint behavior under structure ultimate load. Joint numerical modelling considerations are enriched with comparison to the full-scale tower pushover test results. Two independent load cases were examined: 1) where the L-sections (diagonal bracings) are loaded by the axial force only and that forces are applied in the center of the member cross section, 2) where the L-sections are loaded by the axial force and the bending moment that reproduce the effect of the eccentric connection to the gusset plates by the one leg of the angle section is added. Differences in equivalent stresses state for two independent design situations allow for conclusion that additional bending moments should be taken into account, especially for thin-walled members.
Authors and Affiliations
Jacek SZAFRAN, Kazimierz RYKALUK
EXAMPLES OF SOLUTIONS FOR STEEL-CONCRETE COMPOSITE STRUCTURES IN BRIDGE ENGINEERING
The aim of the article [1] was to discuss the application of steel-concrete composite structures in bridge engineering in the aspect of structural design, analysis and execution. It was pointed out that the concept of st...
SELECTED PROBLEMS OF APPLYING THE LAW IN ADAPTATION AND MODERNIZATION OF BUILDINGS IN POLAND
Chosen problems of law implementation in the contemporary process of building’s modernization in Poland. One of the major problems in the contemporary process of building’s modernization in Poland is the pluralism of dif...
NUMERICAL HOMOGENIZATION OF ELASTIC BRICK MASONRY
The paper is concerned with a numerical homogenization technique for determination of effective material properties of brick masonry in the elastic range. The homogenization problem is posed in the plane state of stress....
THE PROBLEM OF ADAPTING EXISTING RESIDENTIAL BUILDINGS IN THE COUNTRY TO THE REQUIREMENTS OF ECOLOGY
The article presents the results of direct research on residential buildings and their modernization in selected ecological farms of the Mazovia region. The research area covered two poviats (counties) in the Mazowieckie...
The influence of pH on solubility of copper in soils contaminated by copper industry in Legnica
The aim of the study was to determine the influence of changes in pH on the solubility of copper in soils contaminated by copper industry. Soil samples were collected from the surface soil horizon (0-30 cm) at two sites...