Structural Investigation into the Causes of Cracks in Building and Solutions: A Case Study
Journal Title: American journal of Engineering Research - Year 2018, Vol 7, Issue 8
Abstract
Cracks are commonly found on and in structures and are usually undesirable features naturally occurring due to age, workmanship and other natural and environmental causes. This study is set to characterize cracks with the principal aim of recommending proper maintenance and efficient repair actions. Crack occurrence in an office building (storey with basement) was investigated as a case study. Reconnaissance survey was carried out to locate and note the tools that would be required for the investigation of the cracks. Visual examination and measurement of cracks to know the cause and type of each crack were performed. Strength test of all the structural members was done using Schmidt hammer to determine the residual strength of the members on which they appear and the results were analyzed. The results of the reconnaissance survey revealed that most of the cracks are located at the left side than at right side elevation of the building. The nature of the cracks showed that 91% are dormant cracks, while 9% are active cracks. Some of the cracks extended to the plastered surface, while the rest extended to the structural elements region. Therefore, the cracks in this building were found to be caused by the drying shrinkage at the wall section, the compressive force from the beams exceeding the ultimate strength of the affected blocks, foundation settlement at the courtyard was also discovered through topographical survey, due to underground erosion of the foundation wall footing. The results of the non-destructive test (NDT) indicated that, the average strength of the structural elements is within acceptable limit.
Authors and Affiliations
Ajagbe W. O* 1,, Ojedele O. S
Keywords
Related Articles
- EP ID EP398443
- DOI -
- Views 74
- Downloads 0
A Novel High Performance Bridgeless Ac-Dc Boost Converter
A new single phase high performance bridgeless AC-DC Boost converter is proposed. The converter is made bridgeless by the use of two unidirectional switches and two diodes at the input ac side for power conversion for bo...
Spectroscopic Properties of Pr3+ Ions Embedded in Different Multi Component Phosphate Glasses
Pr3+ doped multi component phosphate glasses were prepared by conventional melt quenching technique. The structures were characterized by XRD, Fourier transform infrared and solid-state 31P NMR techniques. Optical absorp...
Web-Based Application for the Sizing of a Photovolatic (PV) Solar Power System
The harnessing of solar energy, especially for provision of energy for residential consumption, has been on the rise in developing countries, especially Nigeria, in recent times. Due to this reason, there is the need for...
Design And Fabrication Of A Prototype Decorticator To Remove Seed Coat Of Black Cumin (Nigella Sativa)
Black cumin (Nigella sativa) seed is very important and widely used seed in traditional medicine. Since, black cumin seeds have been enveloped with a thick seed coat in black color, potential for commercial applications...
Analysis of Transit User Satisfaction using Structural Equation Models
This study aims to understand the relationships among various transit system and service variabl es and transit user satisfaction. The dataset is utilized to test the hypothesis postulated in this study using Struct ural...