Study and Evaluation for the Double-Chambered Incinerator Using Biomass Gas-Derived From Gasification
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2013, Vol 3, Issue 6
Abstract
This research aims to study for the double-chambered incinerator using biomass producer gas derived from gasification process by adjust the optimal combustion characteristics that can efficiently prevent emissions from being released. 30 kilowatt-thermal of gasifier that can generate an average of 18 m3 per hour of producer gas at the maximum fuel input rate of 15 kg per hour. The incinerator prototype consists of 2 combustion chambers with 2 gas burners installed, one for sample meat combustion and one for pollution elimination. The calculated proper volume of the primary chamber and secondary chamber were 0.10 m3 and 0.03 m3 , respectively, in order to maintain an adequate combustion residence time. The experiment shows the temperature of the primary and secondary rooms can achieve a maximum of 750oC and 500oC, respectively, when 100% of excess air condition was carried out. Meanwhile, a large input of excess air decreased the temperature inside the combustion chambers and also increased the flue gas opacity, which meant an increase of exhaust pollution in the atmosphere. In addition, an evaluated efficiency of the incinerator was 29-32 percent if only the primary chamber was operated. Accordingly, biomass producer gas is a feasible and appropriate renewable energy source to utilize as the main fuel for a double-chambered crematory in order to cremate the corpse and eliminate pollution simultaneously.
Authors and Affiliations
Yaowateera Achawangkul
Keywords
Related Articles
- EP ID EP120897
- DOI -
- Views 142
- Downloads 0
Modeling and Manufacturing of Powered vehicle for physically challenged people
This vehicle is suitable for physically challenged or disabled people. I proposed complete customized solutions for physically challenged drivers and patents also. This proposed vehicle successfully dealing with el...
Optimization of machining parameters of Electric Discharge Machining for 202 stainless steel
: Electric discharge machining is used for machining of hard materials like steel. In this paper, the effect of electrical discharge machining (EDM) parameters such as pulse-on time (TON), pulse-off time (TOFF),...
Enhance Example-Based Super Resolution to Achieve Fine Magnification of Low Resolution Images Using Neighbour Embedding Method
Images with high resolution (HR) often required in most electronic imaging applications. There are two types of resolution first is high resolution and other one is low resolution. Now high resolution means pi...
Study of Performance of Different Blends of Biodiesel Prepared From Waste Cottonseed Oil
The use of biodiesel is rapidly expanding around the world, making it imperative to fully understand the impacts of biodiesel on the diesel engine combustion process and pollutant formation. Biodiesel was made...
Comparative Studies on Exhaust Emissions from Two Stroke Copper Coated Spark Ignition Engine with Alcohol Blended Gasoline with Catalytic Converter
Experiments were conducted to control the exhaust emissions from four stroke, variable speed, variable compression ratio, single cylinder, spark ignition (SI) engine, with alcohol blended gasoline (80% gasoline, 10% meth...