Study of Four Element Microstrip Antenna Array Using Patch Type Electromagnetic Band Gap Structure
Journal Title: Engineering, Technology & Applied Science Research - Year 2018, Vol 8, Issue 5
Abstract
This paper describes enhancements in the performance of four element microstrip antenna array. The conventional microstrip antenna array is producing gain equal to 6.81dB. With the introduction of U shape patch type electromagnetic band gap structure, the proposed microstrip antenna array is producing an improved gain of 20.33dB. It is producing reduced mutual coupling of -31.44, -36.41 and -31.62dB respectively. The radiation characteristics of the proposed microstrip antenna array are improved with appreciable decrease in back lobe radiation and increase in forward power. It is resonating at single band at 5.53GHz, producing an overall bandwidth of 109.45%, against 4.89% of conventional microstrip antenna array. Microstrip antenna arrays are designed using Mentor Graphics IE3D software and measured results are obtained using vector network analyzer.
Authors and Affiliations
K. P. Rao, P. V. Hunagund, R. M. Vani
Modeling a Distributed Power Flow Controller with a PEM Fuel Cell for Power Quality Improvement
Electrical power demand is increasing at a relatively fast rate over the last years. Because of this increasing demand the power system is becoming very complex. Both electric utilities and end users of electric power ar...
Modeling Support Loss in Torsional Mode Vibrations of a Micromechanical Disk Resonator with Two L-Shaped Support Beams
In this paper, a new micromechanical disc resonator with two L-shaped horizontal support beams in torsional mode vibrations has been proposed. The proposed micromechanical resonator has been studied in the field of natur...
Microstructure and Wear Behavior of TiC Coating Deposited on Spheroidized Graphite Cast Iron Using Laser Surfacing
Spheroidal graphite cast iron was laser cladded with TiC powder using a YAG fiber laser at powers of 700, 1000, 1500 and 2000 W. The powder was preplaced on the surface of the specimens with 0.5 mm thickness. Sound cladd...
Implementation of a Flexible Bayesian Classifier for the Assessment of Patient’s Activities within a Real-time Personalized Mobile Application
This paper presents an implementation of a mobile application that provides a real-time personalized assessment of patient’s activities by using a Flexible Bayesian Classifier. The personalized assessment is derived from...
Enhancing the HVRT and LVRT Capabilities of DFIG-based Wind Turbine in an Islanded Microgrid
Doubly fed induction generator (DFIG) based wind turbines are very sensitive to grid voltage variations. Therefore, low-voltage-ride-through (LVRT) and high-voltage-ride-through (HVRT) capabilities are employed to improv...