STUDY OF WEAR RESISTANCE OF REINFORCED POLYAMIDE COMPOSITES FOR METAL-POLYMER GEAR DRIVES
Journal Title: Tribologia - Year 2018, Vol 279, Issue 3
Abstract
An experimental study of the wear resistance of two dispersion-filled composite materials based on polyamide used in metal-polymer gear drives with a 30% volume content of short glass or carbon fibres was performed according to the technique proposed by the authors. As a result of tribotests in the “pin-disk” scheme, the mass wear of these composites was determined under dry friction conditions for steel 45 at room temperature in the range of contact pressures of 10–40 MPa, as well as the kinetics of the coefficient of sliding friction and the contact temperature of the tribosystem elements. It was established that polyamide strengthened by carbon fibres has almost four times higher wear resistance in comparison with a polyamide filled with glass fibres. The wear resistance characteristics that are the basic parameters of the tribokinetic wear model are calculated, using the durability of the straight spur metal-polymer gear drive on the basis of the original calculation method. It was established that gear drive durability with a pinion or a wheel reinforced with carbon fibres is more than eight times the durability of gear drive with gear wheels from polyamide filled with glass fibres. The gear drive durability with the steel pinion and the composite gear wheel increases in proportion to the gear ratio as compared to the gear drive with the composite pinion and the steel wheel. The change in the maximum contact pressures in the mesh interval was calculated.<br/><br/>
Authors and Affiliations
Myron CHERNETS, Serge SHIL'KO, Mikhail PASHECHKO
Keywords
Related Articles
- EP ID EP403174
- DOI 10.5604/01.3001.0012.7003
- Views 36
- Downloads 0
ANALIZA WŁAŚCIWOŚCI TRIBOLOGICZNYCH WYBRANYCH KOMPOZYTÓW POLIMEROWYCH NA BAZIE PTFE WSPÓŁPRACUJĄCYCH ŚLIZGOWO Z TLENKIEM GLINU (Al2O3)
W artykule przedstawiono mikrostrukturę, właściwości mechaniczne i tribologiczne kompozytów polimerowych na osnowie politetrafluoroetylenu z myślą o zastosowaniu w węzłach tarcia urządzeń realizujących ruch posuwisto-zwr...
CHARAKTERYSTYKI TRIBOLOGICZNE WĘGLIKOWYCH WARSTW CHROMOWANYCH WYTWARZANYCH METODĄ PROSZKOWĄ PRZY OBNIŻONYM CIŚNIENIU
W pracy przedstawiono wyniki badań dotyczących chromowania dyfuzyjnego stali narzędziowej metodą proszkową zmodyfikowaną przez zastosowanie obniżonego ciśnienia podczas procesu dla uniknięcia utleniania wsadu. Procesy ch...
THE INFLUENCE OF THE NUMBER OF RESEARCH COURSES ON THE ESTIMATION OF CONTACT FATIGUE LIFE SCATTER OF LUBRICATED ROLLING FRICTION PAIRS
The article presents the research results of value changes of contact fatigue life scatter caused by changes of the number of research courses in the tribological experiment. The presented work is the continuation of the...
HYDRODYNAMIC THRUST BEARINGS WITH POLYMER LINING
Polymeric linings of sliding surfaces of the hydrodynamic bearings have been used successfully for over 50 years. Despite of their long history of operation and research, they have not become widespread in industrial app...
Adhesive wear of selected tool steels used for injection moulds manufacturing