Substantiation of Parameters and Analysis of Operational Characteristics of Oscillating Systems of Vibratory Finishing Machines
Journal Title: Український журнал із машинобудування і матеріалознавства - Year 2017, Vol 3, Issue 2
Abstract
The calculation diagrams of oscillating systems and operation features of vibratory finishing machines are considered. The mathematical models of three-mass and four-mass oscillating systems are presented. The amplitude values of the oscillating masses displacements are derived. The functions of inertial and stiffness parameters optimization are formed. The optimization problems are solved with a help of MathCAD software. On the basis of synthesized inertial and stiffness parameters, the amplitude-frequency characteristics of the oscillating systems of vibratory finishing machines are formed and analyzed. In order to verify the validity of the proposed theoretical approaches, the simulation of the mathematical model of the oscillating system motion is carried out by means of numerical solving of the system of differential equations of the oscillating masses motion. The proposed structural diagrams and the operation schemes of the vibratory finishing machine, as well as the derived analytical formulas may be used by designers, researchers and technologists while improving existent and developing new equipment for vibro-finishing treatment.
Authors and Affiliations
Vitaliy Korendiy, Viktor Zakharov
Keywords
Related Articles
- EP ID EP281284
- DOI 10.23939/ujmems2017.02.067
- Views 202
- Downloads 0
Heat generation and heat consumption in engine of rapid internal combustion
The research of heat generation and heat consumption in a conventional or ideal engine provides useful information about the regularities, character of the process and effectiveness of fuel combustion in any real engine...
Hydrocutting of Frozen Food Products
The article aims to determine the peculiarities of macromolecule deformation behavior under conditions of a jet-shaping head that would allow to solve the issue related to the mechanism of increasing water-jet cutting po...
Investigation of the Carbide-tipped Tool Wear Hardened by Method of Aerodynamic Impact
Theoretical calculations and experimental studies of the influence of wear on the cutting process and the precision parameters of machining by hard alloys during milling are described in the article. The method of aerody...
Computation of Shaping Errors for Fine Boring of Smooth and Stepped Holes
On the basis of precision theory we propose the method of computation of static and dynamic errors of cross-sectional shapes of holes in fine boring of smooth and stepped holes. We consider particular cross-sectional sha...
Regulation of the phase-structural composition and metastability of austenite by alloying elements and parameters of tempering for increase wear-resistance of Fe-Cr-Mn deposited steel
It is shown that under the influence of alloying (Cr, Mn, C, Si, Ti, N, V) during electric arc hardfacing with a flux cored wire, as well as technological tempering parameters at temperatures of 300...700°C, the phase-st...