Substation Automation System for Energy Monitoring and Control using SCADA
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2017, Vol 5, Issue 3
Abstract
Inherent scarcity of thermal sources with a time varying temperature profile is the reason why the Thermo electricbased energy harvesting is not as prominent as its counter-part, thermoelectric generators, in the thermal energy harvesting domain. The main focus of the work is to modulate the concentrated solar radiation using a vertical axis wind turbine for producing higher rate of change of temperature on the Thermo electric material. In a typical demonstration of thermoelectricity, one part of the device is kept at one temperature and the other part at a different temperature and the result is a permanent voltage across the device as long as there is a temperature difference.
Authors and Affiliations
Sam Joel Raj. T, Aravindhan. P, Dharan Kumar. R , S. Kanchana
Keywords
Related Articles
- EP ID EP23693
- DOI http://doi.org/10.22214/ijraset.2017.3231
- Views 371
- Downloads 7
Security on VoIP
Voice over Internet protocol (VoIP), is a way of communicating over Internet. It is one of the newest technology. There is an existing way of communication over any network. The Users can make the telephone calls over a...
IP Routing In Computer Networks
The term routing is used for taking a packet from one device and sending it through the network to another device on a different network. The logical network address of the destination host is used to get packets to a n...
Weight Optimisation and Burst Margin of Aero Engine Compressor Disc
Rotating disks are heavy, highly stressed components used in gas turbine mainly due to over speed and operating temperatures. In this work compressor disc are concentrated. The objective of this work was to develop fini...
Analysis of Card controlling System in Conwip, Kanban and Base Stock Control System
Productive production control system is that which produce the right parts, at the right time at a comparable cost. These schemes are often referred to as just–in–time, push or nil inventory. In push system uses card se...
Gas Level Alert and Automatic Cut-Off in a Stove
this paper proposes a technique which lets us to completely eliminate any mishappenings that generally occur with the leakage of gas in a daily base Gas stove system. The system can be operated in a way as to check whet...