Surface Roughness analysis of drilling on GFRP composites by experimental investigation and predictive modeling
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2014, Vol 2, Issue 9
Abstract
Glass Fiber Reinforced Plastics composites have an increased application in recent days, due to its enhanced structural properties, Mechanical and thermal properties. Drilling of holes in GFRP becomes almost unavoidable in fabrication. The heterogeneous nature of this kind of materials makes complications during machining operation. However, drilling is a common machining practice for assembly of components. The quality of holes produced in the GFRP material is severely affected by surface roughness, Circularity and Delamination . The objective of the study is to apply the full factorial design, ANOVA and Fuzzy logic model to achieve an improved hole quality considering the minimum surface roughness through proper selection of drilling parameters. The regression method is employed in the Experimental investigation and Mathematical modelling of drilling of GFRP material using HSS drill bits and the fuzzy logic model for the validation of the mathematical model.
Authors and Affiliations
Prasanna Ragothaman, Harihar Karthikkeyan
Energy Efficient Routing Protocol Considering Residual Energy in Wireless Adhoc Networks
Wireless networks adapt easily to changes and offers flexibility in the configuration of the network. In MANET, each node will change its location dynamically and configure itself according to the environment. An effect...
Review on Behaviour of Outrigger System on High Rise Structure by Varying Outrigger Depth
Tall building development has been rapidly increasing worldwide introducing new challenges that need to be met through engineering judgment. In modern tall buildings, lateral loads induced by wind or earthquake are ofte...
Application of Ranked Position Weighted (RPW) Method for Assembly Line Balancing
Line balancing is an effective tool to improve the throughput of assembly line while reducing, cycle time. Line balancing is the problem of assigning operation to workstation along an assembly line, in such a way that a...
Optimization of Dry Turning Process Parameters using Taguchi and ANOVA Technique for MRR of EN8 Steel
Turning operation is a material removal process generally used to remove the material from the surfaces to achieve the desired dimension of the product. An L9 orthogonal array, S/N ratio and ANOVA are employed for analy...
Voltage Stability Enhancement in SCIG Based Wind Farm Using Facts with Unbalanced Fault
The stability of fixed speed wind turbines can be improved by a STATCOM, which is well known and documented in literature for balanced grid voltage dips. Under unbalanced grid voltage dips the negative sequence voltage...