TDA method application to austenite transformation in nodular cast iron with carbides assessment
Journal Title: Archiwum Odlewnictwa - Year 2011, Vol 11, Issue 3
Abstract
In this paper the possibility of TDA method using to austenite transformation in nodular cast iron with carbides assessment is presented. Studies were conducted on cast iron with about 2% molybdenum and 0,70% to 4,50% nickel. On diagrams, where TDA curves are pre-sented, on time axis a logarithmic scale was applied. It has not been used up to now. It was found, that during cooling and crystallization of cast iron in TDA probe, on the derivative curve there is a slight thermal effect from austenite to upper bainite or martensite transformation. Depending on nickel concentration austenite upper bainite transformation start temperature changed (Bus), while MS temperature was independent of it. An influence of nickel on eutectic transformation temperature in nodular cast iron with carbides was determined too.
Authors and Affiliations
G. Gumienny
Keywords
Related Articles
- EP ID EP72376
- DOI -
- Views 129
- Downloads 0
Evaluation of Synthetic Gypsum Recovered via Wet Flue-Gas Desulfurization from Electric Power Plants for Use in Foundries
This article investigates possible use of waste gypsum (synthetic), recovered via flue-gas desulfurization from coal-fired electric power plants, in foundries. Energy sector, which in Eastern Europe is mostly composed fr...
The influence of the conditions of gypsum plaster preparation on its technological properties
The results of researches on influence of basic preparation parameters, i.e. time and mixing intensity, start and end time of set, dimensional changes and strength of gypsum plaster, are presented in this paper. Determi...
Characteristic of intermetallic phases in cast dental CoCrMo alloy
Apart from chromium and molybdenum, casting alloys of cobalt usually contain also up to 0.35 % of carbon. With significant content of carbon, presence of carbide-forming alloying elements results in creating carbide phas...
Influence of the heat treatment on the microstructure and properties of austenitic cast steel
Exploitation investigations of a centrifugally cast pipe of austenitic cast steel indicated a significant influence of its microstructure on functional properties. Determination of the possibility of forming the microstr...
Microhardness and tribological wear of the steels remelted with an electric arc
This study presents results of a research on the surface strengthening of the C15, C45 and C90U steels by application of concentrated heat stream with the GTAW methodology. Utilizing the GTAW methodology remelting of the...